In the last years pulsed fiber lasers and amplifiers attract great attention for applications required high repetition rate and average power. At 2006 4.5 MW peak-power Yb-doped fiber amplifier emitting near diffraction-limited output beam have been reported [1]. These results were enabled by double clad large-core amplifier fibers and 100 mm core rode-like Yb-doped photonic crystal fiber.

In this report we present experimental results of the investigation of one-stage Yb-doped double-clad large-core fiber amplifier using as a seed the radiation of microchip Nd:LSB (duration 0.6 ns) and Nd:YAG (duration 1.2 ns) (both UAB „Standa“ product). From the other hand laser system based on the seed laser and the fiber amplifier could be perspective source for the nonlinear frequency converters pump, and find more important applications. The amplified seed laser radiation was used for pump KTP optical parametric oscillator (OPO).
In fiber amplifier 3 meter long, 30 mm core diameter double-clad Yb-doped NUFERN production fiber were used. Fiber amplifier was pumped by 8.8 W power diode-laser radiation (975 nm). For higher transversal mode discrimination the fiber was rolled-up into 8.5 cm diameter bobbin. Fig. 1. shows intensity distribution of amplified radiation (a), and M2 measurements results (b). Amplified radiation was close to diffraction limited: M2x=1.05; M2y=1.1.
Fig. 2. shows amplified signal energy versus fiber amplifier pump power for different seed pulses repetition rate.

As seen from the figure maximum energy (~250 μJ) was achieved when the repetition rate was 2-4 kHz (for 1.2 ns pulses). For the maximum amplified pulse energy intensity was ~0.4 MW, the spectrum of the radiation was increased from 1 to 3.5 GHz by nonlinear processes as phase-modulation and SRS. The spectrum width of 0.6 ns duration pulses increased to 7 GHz. In both cases stimulated Brillouin scattering were not observed. Fig. 2. presents fiber amplifier output radiation spectra measured by Fabri-Perot interferometer for different signal energy.
Good amplified beam quality allows with 60% efficiency generate second harmonics (8 mm KTP crystal; $\theta$ = 90°, $\varphi$ = 24°). This radiation for doubly resonant KTP OPO pump was used. Tuning range of OPO was 1.02-1.08 μm and was limited by KTP crystal aperture. OPO efficiency reached 55%.
Experimental results shows that investigated microlaser – fiber amplifier system could be perspective source for nonlinear frequency converters pump.