TOWARDS HIGHLY CONDUCTIVE NANOCRYSTALLISED VANADATE-PHOSPHATE GLASSES

K Gadomski1, T K Pietrzak1, Sz Starzonek2, S J Rzoska3, J E Garbarczyk1

1 Faculty of Physics, Warsaw University of Technology, Poland

2 Laboratory of Physics, Faculty of Electrical Engineering, University of Ljubljana, Slovenia

3 Institute of High Pressure Physics of the Polish Academy of Sciences, Poland

In the last few decades, the growth of renewable power sources has been observed. Unfortunately, those power sources are heavily dependent on weather conditions. For this reason, battery systems are needed for power grid stabilization.

Vanadate-phosphate is a wide group of materials, and it has a long history of research and development. Crystalline VOPO\(_4\) was investigated by e.g. M. S. Whittingham’s team [1], Li\(_3\)V\(_2\)(PO\(_4\))\(_3\) was studied by e.g. L. F. Nazar’s team [2]. However, corresponding glasses, including vanadate-phosphates, were at the edge of mainstream researches. E.g., 90 V\(_2\)O\(_5\) \(\cdot\) 10 P\(_2\)O\(_5\) glasses and nanomaterials were studied by T. K. Pietrzak’s team [3, 4]. Glassy material has conductivity around \(\sigma\) = 7 \(\cdot\) \(10^{-5}\) S/cm but after nanocrystallization the electronic conductivity dramatically increased to the level of \(\sigma\) = 7 \(\cdot\) \(10^{-2}\) S/cm at room temperature. Moreover, gravimetric capacity was also determined for this highly conductive material and it was at the level of 225 mAh/g in first cycle (C/20 current), but it dropped to 140 mAh/g in the third cycle.

The objective of this work is to synthesise a glassy analogue of 95 V\(_2\)O\(_5\) \(\cdot\) 5 P\(_2\)O\(_5\) (i.e., with a higher content of vanadium) and optimize its electronic conductivity. For this purpose, many different measurement methods were used: XRD, SEM and EDX to confirm the glassy state, shape of the surface and to determine percentage of impurities, DSC to check glass thermal stability, and DC for electrical measurements. With this method, changes in material during heat treatment can be described, and correlations between changes in conductivity and other structural factors will be shown.

This work was supported by the National Science Centre (NCN, Poland) through OPUS-23 grant no. 2022/45/B/ST5/04005


[1] Z. Chen et al.: Electrochemical Behavior of Nanostructured e-VOPO4 over Two Redox Plateaus. J. Electrochem. Soc. 160 (2013) A1777

[2] H. Huang et al.: Nanostructured Composites: A High Capacity, Fast Rate Li3V2(PO4)3 Carbon Cathode for Rechargeable Lithium Batteries. Adv. Mater., 14: 1525-1528

[3] T.K. Pietrzak et al.: Electrical properties vs. microstructure of nanocrystallized V2O5-P2O5 glasses. Journal of Power Sources 194 (2009) 73-80

[4] T.K. Pietrzak et al.: Highly Conductive 90V2O5-10P2O5 Nanocrystalline Cathode Materials for Lithium-ion Batteries. Procedia Engineering 98 (2014) 28-35