Theoretical model is developed of self-organsation effects in chromium layer under incident laser beam. In the actual experiment the beam of a nanosecond pulse laser tightly focused to a line was applied for the back-side ablation of the chromium thin film on a glass substrate. The stripe ablated with a single laser pulse had sharp edges on both sides and ridges of the melted metal around it. Subsequent partially overlapping pulses formed a wide cleaned area with a complicated structure made of the metal remaining from the ridges. Regular structures, ripples, were developed when the shift between pulses was less than half width of the line ablated with a single laser pulse. The ripples were located periodically (4 μm) and were orientated perpendicularly to the long axis of the beam spot. Different theories of the ripple formation in the thin metal film were considered. One of the most probable reason for such metal layer behaviour appears to be surface tension of the boundary air-liquid metal dependence on temperature. This model is developed to estimate the influence of this effect.
The theorem, which describes surface tension dependence on temperature influence to fluid flow near the free surface is known as Marangoni effect. It states that surface tension $\sigma$ depends on temperature T. Expanding surface tension up to the first order in temperature, we obtain
$$ \frac{\partial \sigma}{\partial x} = \frac{\partial \sigma}{\partial T} \frac{\partial T}{\partial x} \tag{1} $$We omit surface tension dependence on concentration. This equation is applied to boundary condition of air – liquid metal boundary
$$ \eta \frac{\partial v_x}{\partial y} = \frac{\partial \sigma}{\partial T} \frac{\partial T}{\partial x} \tag{2} $$Where $\eta$ is dynamic viscosity of liquid material, $v_x$ is the tangential component of velocity and y is the normal coordinate.
Full Navier – Stokes equation system needs to be considered because of significant non-linearity effects of the fluid flow:
$$ \rho \left( \frac{\partial \mathbf{v}}{\partial t} + \mathbf{v} \cdot \nabla \mathbf{v} \right) = -\nabla \rho + \mu \nabla^2 \mathbf{v} + \mathbf{F} \tag{3} $$$$ \nabla \cdot \mathbf{v} = 0 \tag{4} $$The standard diffusion equation was used for temperature dissipation.
Comsol Multiphysics 3.5 was used for a computational scheme. Moving mesh is also required to model this situation. Calculations to this fully coupled multiphysics simulation was carried out for a wide range of parameters. Typical results are represented in Fig.1 and Fig. 2

