Semiconductor device characteristics are determined, to a large extent, by intrinsic and extrinsic defects. Consequently deep level induced variations in static and dynamic device characteristics are subjected to intensive research. Moreover, results of these studies are essential for further developments in semiconductor device fabrication technologies and deeper understanding of defect caused phenomena.
Built-in potential and its stability under intense irradiation are considered to be an essential characteristic of solid state particle detectors. Dependencies of these parameters are traditionally studied by analysis of steady state current-voltage and ac small signal capacitance-voltage characteristics. However, possible implementations of the mentioned methods are limited by noise levels in measurement circuits and the linear range of response amplitudes, i.e. commonly used LRC meters are developed to measure parameters in linear elements.
In this work, a technique based on measurements of barrier charging and charge extraction current transients caused by linearly increasing voltage (BELIV) is proposed as an alternative to traditional methods. The principle of the BELIV method is discussed. Characteristics measured in Si pin diodes under various experimental conditions, such as reverse and forward biasing at various temperatures and steady-state illumination, are presented. Simulated and measured characteristics of the BELIV signal dependent on density of deep-level traps are compared.