BARRIER CAPACITANCE CHARGING CURRENT TRANSIENTS DEPENDENT ON BIAS ILLUMINATION IN Si pin DIODE STRUCTURES

Adomas Tumas1, Tomas Čeponis1, Eugenijus Gaubas1

1 Institute of Applied Research, Vilnius University, Sauletekio Ave. 9-III, LT-10222 Vilnius, Lithuania

Barrier capacitance charging current transients provide comprehensive information on junction doping, carrier generation current and fast traps inside diode base region [1]. The barrier evaluation by linearly increasing voltage (BELIV) technique [2-4] proved to be an efficient tool to examine switching rate, carrier emission time scale and to evaluate barrier capacitance. In this work, the BELIV technique was applied to examine the fluence dependent variations of barrier capacitance charging currents in reactor neutrons and accelerated protons irradiated pin diodes. To highlight the impact of radiation defects, the BELIV technique is combined with bias illuminations.

A set of Si pin diodes of CERN standard particle detectors and of industrial power switchers has been investigated. The doping density of base region was 1012 cm-3 in particle detectors and 7×1014 cm-3 in power switchers, respectively.

Room temperature BELIV transients were examined varying linearly increasing voltage (LIV) pulse durations and amplitudes. Simultaneously, intensity of broad spectrum bias steady-state illumination was varied.

BELIV transients showed a decrease of barrier capacitance with enhancement of irradiation fluence. This reduction of barrier capacitance is explained by a reduction of effective doping due to radiation induced carrier traps. Bias illumination appeared to be efficient to suppress traps and to recover partially barrier capacitance. The rise to peak times as a function of bias illumination intensity also was analyzed. These characteristics enabled us to evaluate changes of the serial resistance within diode base region under radiation damage and traps charging.

The parameters of carrier generation lifetime and of effective doping have been extracted. Variations of these parameters dependent on irradiation fluence and on defect distribution profile will be presented and discussed.


[1] E. Gaubas, T. Ceponis, and J. Kusakovskij, REVIEW OF SCIENTIFIC INSTRUMENTS 82 (2011) 083304

[2] E.Gaubas, T.Čeponis, S.Sakalauskas, A.Uleckas, and A. Velička, LJP (Lithuanian Journal Physics), 51 (2011) 227-233.

[3] E. Gaubas, T. Ceponis, A. Uleckas and R. Grigonis. JINST (Journal of INSTrumentation), 7 (2012) P01003.

[4] E.Gaubas, T.Čeponis, V.Kalendra, J.Kusakovskij, and A.Uleckas, ISRN Materials Science, vol. 2012, article ID543790, 17 pages doi:10.5402/2011/543790