DLTS SPECTROSCDOPY ON SI SOLAR CELLS

Vaidvilė Ulbikaitė1, Eugenijus Gaubas1, Aurimas Uleckas1

1 Institute of Applied Research, Vilnius University, Saulėtekio av. 9-III, LT-10222 Vilnius, Lithuania

To optimize the conversion efficiency of photovoltaic cells within design and manufacturing of junction structures, spectrum and density of deep traps, introduced during technological procedures of Si material growth and junction formation, are very important characteristics. One of the ways to reach the highest conversion efficiency of solar cells is to minimize or suppress the recombination processes in the $p-n$ junction of solar cell [1]. Commonly these traps are examined and identified using deep level transient spectroscopy technique [2].

In this work, Deep Level Transient Spectroscopy (DLTS) has been employed to identify specific defects and to evaluate density of these deep centres within base region of Si solar cells fabricated at enterprise „PRECIZIKА МТС“. Two peaks have been clearly resolved within deep level spectra measured on two sets of samples, made by slightly different technology. It has been revealed that metal Cu and Ni ascribed traps dominate within these deep level spectra. Density of Ni ascribed traps observed at 260 K within temperature scan DLTS spectra was found to be of the order of magnitude 1014 cm-3. In different set of the investigated junction Si solar cell structures, density of Cu associated traps (observed at 150 K within temperature scan DLTS spectra) was evaluated to be (1-3)× 1014 cm-3, i.e. of the same order as Ni impurities. Introduction of metal traps is associated with imperfection of metallization technological processes.


[1] A.Luque and S.Hedegus, Handbook of photovoltaic science and engineering. John Wiley & Sons, England, 2003.

[2] P.Blood and J.W. Orton, The Electrical Characterization of Semiconductors: Majority Carriers and Electron States (Academic Press Inc., San Diego, 1992).