NIOBIUM AND SILICON DIOXIDE THIN FILMS PROCESSING USING REACTIVE MAGNETRON SPUTTERING

Rimantas Žičkus1, Kęstutis Juškevičius2

1 Faculty of Physics, Vilnius University, Sauletekio Ave 9, build. 3, LT-10222 Vilnius, Lithuania

2 Institute of Physics, Center for Physical Sciences and Technology, Savanoriu ave. 231, LT-02300 Vilnius, Lithuania

Up to the mid-1970s the evaporation dominated over the sputtering of solid materials in the physical vapor deposition (PVD) of thin films technologies but the breakthrough arrived in 1974 when the planar magnetron was discovered. From this moment, a very intense development started. The main principle of magnetron sputtering method is controlling magnetron discharges, plasma and high-energy charged particles by magnetic fields and keeping them in appropriate vicinity of the sputtered target and the substrate. These physical conditions and other properties (target materials, substrate-to-target distance, gas total or partial pressure and flow, magnetron vertical axis angle, discharge voltage $U_d$ and etc.) are accountable for growing films process and its characterization (duration and sputter deposition rate v, particle energy, ionization, layer density and thickness). The aim of magnetron sputtering method development is applying it in the fabrication of thin films.

In our experiments and observations we attempt to figure out operating modes of magnetron sputtering method, features and issues of condition combinations, characterize main advantages and disadvantages.

Firstly, it was checked how cooling system works in order to ensure stable and fail-safe performance. No lacks and target over-heating were established using niobium (Fig. 1), the dependences of target voltage vs power after 30 min were compared with previous experiments and no big difference observed, which is important for continuous sputtering processes. The next monitoring related reactive gas (RG) flow and sputtering speed. Obtained result is shown in Fig. 2. and it is called hysteresis loop.

Figure 1 & 2 & 3
Fig. 1. Dependence of target voltage vs time at different power level.
Fig. 2. Hysteresis of reactive Nb sputtering at different powers.
Fig. 3. Schematic illustration of hysteresis effect.

The hysteresis effect arises in consequence of two competitive processes: the sputtering of the target surface and the covering of its surface by reaction products. At low values of RG flow rate $\phi_{RG}$ (Fig. 3, interval A–B) all RG is gettered by the sputtered material. In the point B, every small increase in $\phi_{RG}$ results in a jump of the film deposition rate v. A further increase of $\phi_{RG}$ (interval C–D) results almost constant value of v, which is typical for reactive mode of sputtering. The decrease of $\phi_{RG}$ from D to E is accompanied by the decrease of $p_{RG}$, but a return to the interval E–C is delayed. This is because $p_{RG}$ remains high until the compound layer on the surface of sputtered target is fully removed and material is again exposed to be sputtered. As a result, the consumption of RG increases and $p_{RG}$ decreases to a background level. This way a closed hysteresis loop is formed.

The next step is defining optimal conditions for Si and Nb sputtering, measuring uniformity, roughness, thickness, microstructure and other properties of films on substrates (optical coatings). Further, solving other disadvantages (for example, removing insulating layers formed on the uneroded areas of sputtered target and avoiding arcing in process), improving control of the energy of condensing and bombarding ions over a wide range of sputtering gas pressure, increasing of the ionization of atoms and optimize magnetron reactive sputtering systems and etc.

Acknowledgments: Rimantas Žičkus acknowledges Student Research Fellowship Award from the Lithuanian Science Council.


[1] Y. Pauleau (Ed.), Magnetron Discharges for Thin Films Plasma Processing (Chapter 3), Materials Surface Processing by Directed Energy Techniques, Elsevier (2006), p. 67.