FLUENCE DEPENDENT CAPACITANCE-VOLTAGE AND CURRENT-VOLTAGE CHARACTERISTICS IN Si PARTICLE DETECTORS IRRADIATED BY REACTOR NEUTRONS

Remigijus Dvaranauskas1, Tomas Čeponis1, Eugenijus Gaubas1

1 Institute of Applied Research, Vilnius University, Sauletekio Ave. 9-III, LT-10222 Vilnius

Future high energy physics experiments such as experiments at CERN, will use silicon detectors for fast and high precision tracking of particles. Heavily irradiation by high energy particles causes the formation of extended defects inside the metallurgic junction area. The radiation defect attributed energy levels are introduced into the bandgap thus changing the electrical properties such as leakage current, full depletion voltage UFD and charge collection efficiency (CCE). Enhanced leakage current is observed after irradiation, and this leads to the enhanced electronics noise and to decrease of the spatial resolution of particle detectors. UFD might either increase after irradiation, when radiation donors are introduced, or a full depletion state can be reached without external voltage, when carrier capture centres cause complete reduction of the efficient doping, those eventually lead to the unstable operation regimes of the particle detectors.

In this study, the combined analysis of the capacitance-voltage (C-V), current-voltage (I-V) characteristics and BELIV (barrier evaluation by linearly increasing voltage) characteristics has been performed on Si detectors irradiated by reactor neutrons.

The rectification properties of pin diodes are clearly observed for detectors irradiated with rather small fluencies, while symmetry of I-V characteristics, at forward and reverse biasing, occurs in heavily neutron irradiated diodes. These observations correlate rather well with C-V characteristics measured on the same detectors, when crucial deviations between conductance and impedance C-V characteristics give rise with enhancement of neutron irradiation fluence. The unveiled effects are explained by the increased role of the carrier capture/generation processes within depleted diode base regions. The technique for barrier evaluation by linearly increasing voltage (BELIV) [1-4] based on measurements of current transients at reverse and forward biasing has been additionally applied to comprehensively unveil the reasons of junction degradation under heavy irradiations. The BELIV pulsed technique enables one to clarify a few significant aspects: to identify the charge extraction regime and to estimate a barrier capacitance value, to clarify competition between barrier capacitance charging and generation currents, and to clarify a full depletion state for heavily irradiated diodes. BELIV technique showed a decrease of full depletion voltage with enhancement of irradiation fluence. This observation can be explained by a crucial reduction of the carrier density, when concentration of deep traps significantly exceeds dopants density within defect-rich material surrounding the micro-crystalline columns or inclusions within the polycrystalline structures.


[1] E. Gaubas, T. Ceponis, and J. Kusakovskij, REVIEW OF SCIENTIFIC INSTRUMENTS 82 (2011) 083304

[2] E.Gaubas, T.Čeponis, S.Sakalauskas, A.Uleckas, and A. Velička, LJP (Lithuanian Journal Physics), 51 (2011) 227-233.

[3] E.Gaubas, T.Čeponis, V.Kalendra, J.Kusakovskij, and A.Uleckas, ISRN Materials Science, vol. 2012, article ID543790 doi:10.5402/2011/543790

[4] E. Gaubas, T. Ceponis, and J. Vaitkus, JOURNAL OF APPLIED PHYSICS 110 (2011) 033719.