THE NATURE OF PARAMAGNETIC CENTERS IN MoO3 AND TiO2-MoO3 SYSTEM, OBTAINED BY SOL-GEL ROUTE

Natalia Boboriko1

1 Department of Chemistry, Belarusian State University, Minsk, Belarus

$TiO_2$-MoO3 systems are widely used catalysts in the processes of dehydration, alcohols oxidation [1], ammoxidation [2] et al. These systems are also used for the formation of gas sensing layers in chemical gas sensors [3]. Our earlier investigations [4] showed the availability of using $TiO_2$-MoO3 multioxide systems with different oxide molar ratio as gas sensing material for hydrogen detection. Doping of titanium dioxide with molybdena leads to the increase of sensor response towards hydrogen. However the ascertainment of the mechanism of the influence of doping agents on gas sensing properties needs further investigation. The aim of this work was to establish correlations between gas sensing characteristics of sensors on the basis of molybdena doped titanium dioxide and the nature of the paramagnetic centers of these multioxide systems.

Primary elements for chemical gas sensors on the basis of doped titanium dioxide were formed by sol-gel technique. The procedure of primary elements formation and gas sensing properties measurements is described in [4]. Gas sensing coating was formed from multihydroxide sols. The initial sol of hydrated titanium dioxide was obtained by precipitation by ammonium hydrate from the aqueous solution of titanium chloride in hydrochloric acid, dispersed by ultrasonic and stabilized by concentrated nitric acid. MoO3 sol was prepared by precipitation from ammonium paramolybdate water solution by nitric acid. Sols for $TiO_2$-MoO3 multioxide systems formation were obtained by adding of the calculated amount of ammonium paramolybdate hydrate to the initial sol of titanium dioxide with subsequent ultrasonic treatment. Heat treatment of synthesized sols results in hydroxides decomposition and oxides formation. The content of molybdenum trioxide in the multioxide system was varied from 0.5 to 10 mol.%.

Molybdenum trioxide is a perspective material for gas sensing devices. The peculiarities of its crystalline structure, which consists of two-dimensional networks connected by Van der Waals forces, permits forming superposed structures with oxygen removal. All this makes lattice oxygen along with chemisorbed surface oxygen species active in the processes of thermocatalytic oxidation of burning gases on the surface. The mechanism of gas sensing properties enhancement with molybdena doping can implicate modification of acid-base and redox properties of the surface of multioxide system, which affect adsorption and catalytic activity of the material. Valence- and coordinative-unsaturated metal atoms play the main role in the processes of burning gas detection. Sol-gel method of multioxide system synthesis and the features of molybdenum trioxide chemical nature allow obtaining materials with Mo5+ and Ti3+ centers, which can play the role of adsorption sites for gas molecules. ESR spectroscopy allows detecting paramagnetic centers in gas sensing materials. ESR spectroscopy was carried out for multioxide samples, obtained by sols heat treatment at 600 °C for 2 hours.

The ESR spectrum of molybdenum trioxide, synthesized by sol-gel route, consists of 5 main signals. Paramagnetic center with $g_1$=2,07, $g_2$=2,00, $g_3$=1,97 is fixed and it is attributed to (Mo-O)5+ hole center. In addition line with g=1,97 can be attributed to 6-fold coordinate Mo5+ species with one O2- in its octahedral environment substituted to OH group or H atom: [Mo5+(O2-)5OH] or [Mo5+(O2-)5H+]. Signals with g=1,94 and g=1,89 characterize 6-fold coordinated Mo5+ in crystallographic shear structures. Most of all hole centers O- (g=2,04) and adsorbed anion radicals O2- (g=2,02) are fixed. Investigation of $TiO_2$-MoO3 multioxide systems with different oxide molar ratio by ESR spectroscopy at the room temperature does not give any concrete information on the nature of paramagnetic centers, which exist in the material, as spectrum of these systems consist of one broad line undistinguished from zero line. This broadening does not allow separating signals from certain paramagnetic centers and can be due to strong dipole-dipole interaction between Ti3+ paramagnetic centers from one hand and the consequence of the surface coating with adsorbed oxygen from the other hand. Bearing in mind low concentration of molybdena in $TiO_2$-MoO3 system (up to 10 mol.%) lines from Mo5+ paramagnetic centers in different oxygen environment become undistinguished because of broadening from Ti3+ centers and because of adsorbed oxygen. Partially chemical nature of paramagnetic centers in $TiO_2$-MoO3 systems can be deciphered by the data of paramagnetic centers in MoO3, as crystalline phase of $\alpha$-MoO3 can be registered in the multioxide systems by XRD-analysis. But for complete understanding further researches are to be done.

The research conducted shows that enhancement of gas sensing properties of titanium dioxide with its doping with molybdenum trioxide can be due to the modification of redox and adsorption properties of the sensing material surface. Valence-unsaturated Mo5+ species are registered in MoO3 by ESR spectroscopy, which can couple with Mo6+ and effectively take part in the processes of burning gases molecules oxidation. In addition fixed in the materials hole centers (Mo-O)5+ and O5- can play the role of additional adsorption sites for gas molecules.


[1] Komandur V.R. Chary et al., Characterization and reactivity of molybdenum oxide catalysts supported on anatase and rutile polymorphs of titania, Appl. Catal., A. 208, 291-305 (2001).

[2] Hideaki Yoshitake, Yuko Aoki, Shinnosuke Hemmi, Mesoporous titania supported-molybdenum catalysts: The formation of a new mesophase and use in ethanol-oxygen catalytic reactions, Microporous Mesoporous Mater. 93, 294-303 (2006).

[3] Y.X. Li et al., Microstructural characterization of MoO3-TiO2 nanocomposite thin films for gas sensing, Sens. Actuators, B 77, 27-34 (2001).

[4] N.E. Boboriko, Structural peculiarities of titanium dioxide – molybdenum oxide system and its use in chemical gas sensors, International forum for students "Pervyj shag v nauku-2011", ISBN 978-985-08-1281-0, Minsk, Belaruskaya navuka, 664-667 (2010).