Silicon based detectors are commonly employed in high energy particle detection due to reliability and highly developed technology. Tracking of high energy particles is based either on direct registration of the Ramo's current transients or by collecting particle generated electron-hole pairs [1]. However, high energy particles cause a detector material damage, which leads to permanent degradation of particle detector operational characteristics [1]. As a result, radiation induced defects affect the detectors functional parameters, such as sensitivity, switching speed, charge collection efficiency, etc. On the other hand, the irradiation technologies are routinely applied in semiconductor device industry to optimize a performance of semiconductor devices by reduction of the minority carrier lifetime. In power switchers design, the injected carriers during forward bias cycle should be rapidly removed to reinstate the blocking mode and, thus, to achieve the faster switching speed. Position of fast recombination centres within diode base region is an essential parameter to achieve trade-off between switching speed of device, leakage current and forward voltage drop. Penetration depth of the protons depends on the energy of the beam. Thereby, irradiation with protons of different energy enables one to manipulate location of enhanced recombination layer, induced by irradiations. It is rather well-known technologies [2] how to introduce desirable deep levels within the band gap by irradiation with penetrative particles, e.g. by 2- 10 MeV electron beam.
The bombardment of silicon structures with high energy particles produces a displacement of the Si crystal lattice in the form of vacancies and interstitial atoms. The dominant defects in Si, those are formed by irradiations, are ascribed to complexes of vacancy with impurity atoms and to divacancy. In high resistivity regions of silicon bipolar devices, the divacancy has been identified to be the dominant recombination site for both p-type and n-type regions [2]. Advantages of usage of the irradiation techniques are the allowance of initial testing of device characteristics before and after the irradiation, cleaner process and possibility of recovery of the device characteristics by annealing, in case the device may have received an overdose during the irradiation [2]. The desirable density of defects and location of the enhanced recombination layer can be reached by controlling of the energy and fluence for a proton beam. Therefore, precise evaluation of a density and in-depth distribution profile of defects produced by different irradiation regimes is very important.
In this work, profiles of defect density within a cross-section of a semiconductor device layered structure were examined by measuring carrier lifetime distribution by employing contact-less microwave probed photo-conductivity (MW-PCD) technique. The spatial resolution of MW-PCD technique has been improved by using near-field microwave needle-tip antennas and a focusing system for excitation laser beam. Float Zone (FZ), Czochralski (Cz) Si wafers and diode structures irradiated by protons with energies ranging from 1.5 MeV to 26 GeV were examined, and distribution of defect density was measured. Profiles of carrier lifetime distribution after irradiation by penetrative and stopped particles have been compared. It has been proved that the employed carrier lifetime profiling arrangement reproduces well profiles of radiation damage simulated by TRIM software platform.