SPATIAL DISTRIBUTION OF LUMINESCENCE IN InGaN EPITAXIAL LAYERS WITH DIFFERENT INDIUM CONTENT

Augustas Vaitkevičius1

1 Semiconductor Physics Department, Vilnius University, Saulėtekio Ave. 9-III, LT-10222 Vilnius, Lithuania.

Indium gallium nitride (InGaN) is already commercially used in white and blue light emitting diodes (LEDs), has prospectives for use in electronics and photovoltaics. However, carrier dynamics in InGaN epilayers and heterostructures is still under intense study. One of the key issues under study is spatial inhomogeneity of InGaN compounds. Here, we report on spatial distribution of photoluminescence in InGaN epilayers.

Two sets of InGaN epitaxial layers on sapphire substrate with a GaN buffer layer were analyzed. The samples in the first set were grown under different temperatures, while the growth time vas a variable parameter in the second set of samples.. Both sets of samples were grown by metalorganic chemical vapour deposition at the German based company AIXTRON SE and sent to Vilnius University for characterization. Photoluminescence spatial distribution was measured using confocal technique with 200nm spatial resolution. WITec alpha300 system coupled with a spectrometer was used. Laser diode ALPHALAS emitting at 405nm was exploited for excitation. Photoluminescence measurements were compared to the results on surface morphology obtained using the WITec alpha300 system in atomic force microscopy mode.

In the samples grown at different temperatures, photoluminescence intensity increased with growth temperature up to the highest temperatures used. The highest grow temperatures correspond to the lowest indium content (17%). Spatially averaged spectra shifted to the blue side as the growth temperature increased and In amount decreased, as expected due to a broader band gap of InGaN as the indium content decreases. At higher growth temperatures, photoluminescence was more homogenous leading to a smaller full width at half maximum (FWHM) of the spatially averaged spectra. Correlation between integrated intensity and band peak wavelength changed from anticorrelation to zero correlation as sample growth temperature was increased. Atomic force microscope (AFM) scans revealed that as the temperature growth results in decreasing roughness of the sample surface, indicating a smaller defect density.

The photoluminescence spectrum in the samples grown for different durations consists of two overlapping bands, likely caused by inhomogeneous distribution of In. In the sample with the lowest indium amount the two lines were clearly distinct. Correlation between integrated photoluminescence intensity and peak photoluminescence wavelength changed from positive to negative to near zero as growth time was increased. No difference in photoluminescence homogeneity between samples grown for different durations was observed. Comparison of photoluminescence study and AFM scans revealed that sample roughness and photoluminescence intensity correlate.