CELIV EXPERIMENT AUTOMATION AND OPTIMIZATION

Vytautas Janonis1, Vaidotas Kažukauskas1

1 Institute of Aplied Research, Vilnius University, Saulėtekio Ave. 9-III, LT-10222, Vilnius, Lithuania

Photo induced Carrier Extraction by Linearly Increasing Voltage (CELIV) is a relatively new method of simultaneous determination of charge carrier mobility and lifetime in organic semiconductors, where active layers are few hundred nanometers thick [1]. Other method of carrier mobility investigation in such semiconductors is Time Of Flight (TOF) method, but it has several limitations, which CELIV has not. For example, TOF method sometimes requires up to ten times thicker samples, than that assuring optimal performance of bulk heterojunction solar cells. Moreover, the number of charge carriers in TOF experiments is limited to 10% of the capacitive charge. Also with CELIV samples of high conductivity can be examined, where TOF cannot be used.

The photo-CELIV experimental setup that was used consists of the high power (up to 3 W) light emitting diode, which is controlled by the programmable Agilent 33220A function generator, through the self-made amplifier and fed by the digital TTI QL355P power supply unit. Linearly increasing voltage over the sample is generated by the programmable HAMEG HMF 2550 function generator. The kinetics of the current flowing through the sample was measured by the Tektronix TDS 2022 digital oscilloscope. Sample was placed in the Janis VPF-475 cryostat, and temperature was regulated by the Cryo-Con 32B temperature controller.

The work consisted of two parts. The first one was the optimization of LED performance. To achieve the fast turn on and off of the diode by minimizing effects of transient phenomena the self-built amplifier was developed. With it the noises at the fronts of the light pulses were shortened down to one microsecond. Also in order to quickly change the wavelength of the exciting light five separate diodes with cooling and light focusing elements were made. The second part of the work was connecting all the instruments into one system and controlling all of them via the computer GPIB and USB interfaces by the originally developed program. The program was written in Labview programming environment, so that all experiment can be completed quickly and precisely without tedious manual adjustments. Program itself can separately control the generators, changing basic parameters of the light pulse and the voltage sent to sample separately or together. The voltage sent to the sample has a specific waveform, because of that the program builds an arbitrary waveform and supplies it to the Hameg generator via the USB bus. Temperature control is achieved simply by providing the required value and the program sets the temperature controller to needed settings via the GPIB bus. Kinetics of the extraction current through the sample is recorded and saved to file via the oscilloscope control block, which has 2 separate displays for each input channel and other necessary controls.

A program to measure TSC (thermally stimulated current) was also written in the same environment which also helps to accomplish experiments faster and more conveniently. This program changes sample temperature via the Cryo-Con temperature controller and reads current flowing through it via the combined Keithley 2400 digital electrometer-voltage source. Results are updated and displayed as diagram and graph as they are read.


[1] G. Juška, A. J. Mozer, N. S. Sariciftci, L. Lutsen, D. Vanderzande, R. Österbacka, M. Westerling. Charge transport and recombination in bulk heterojunction solar cells studied by the photoinduced charge extraction in linearly increasing voltage technique, Appl. Phys. Lett. 86, 112104 (2005).