LASER PATTERNING – AN ALTERNATIVE METHOD TO PREPARE SAPPHIRE SUBSTRATE FOR GAN GROWTH

Marius Alsys1, Edgaras Jelmakas1, Roland Tomašiūnas1, Paulius Gečys2

1 Vilnius University, Institute of Applied Research, Saulėtekio Ave. 10, LT-10222 Vilnius, Lithuania

2 Center for Physical Sciences and Technology, Savanoriu Ave. 231, LT-02300 Vilnius, Lithuania

Laser micromachining is a well established technique for fabrication of microstructures [1]. In our work we present use of surface patterning by picosecond laser technique for growth of high quality gallium nitride. Laser ablation is much cheaper and less time consuming technique as photolithography. Quality improvements by use of epitaxial lateral overgrowth (ELO) technique were investigated.

c-plane sapphire surface ablation was accomplished using picosecound Nd:Yag (wavelength 1064 nm) laser, repetition rate – 100 KHz, used wavelength 266 nm (forth harmonic), pulse duration – 10 ps, sapphire surface ablation power 60-670 mW. Laser ablations made across, in parallel, in 30 degrees and in 120 degrees turn in point to a sapphire plane.

After laser ablation sapphire wafers were cleaned using aqua regia (HNO3+HCL, in proportion 1:3 respectively) and etched using sulphuric and phosphoric acids solution (H2SO4 and H3PO4, in proportion 3:1 respectively). SEM images after wet chemical etching shows less surface roughness (Fig. 1) and it could open sapphire crystalline planes.

Figure 1
Fig. 1. 300 mW laser power ablated sapphire wafer surface before and after chemical etching (SEM images)

Undopped gallium nitride samples were grown by metal-organic chemical vapour deposition (MOCVD). GaN growth conditions: III/IV ratio – 1500, reactor pressure 150 mBar, growth rate ~2.1 μm/h temparature – 1065°C. Coalescense layer thickness 1.7 μm, buffer layer thickness 20 nm.

SEM and AFM results shows reduction of dislocation density in gallium nitride layer growth using ELO method on laser patterned (300 mW power) sapphire substrates.


[1] W. Kautek at all. Femtosecond pulse laser ablation of anodic oxide coatings on aluminium alloys with on-line acoustic observation Applied Surface Science vol. 186, pages 374-380, 2002.