PULSE-WIDTH MODULATED LED RESPONSE CHARACTERISTICS AND PSYCHOPHYSICAL COLOR MATCHING

Renārs Trukša1, Sergejs Fomins2, Māris Ozoliņš1, 2

1 University of Latvia, Optometry and Vision Science Department, Kengaraga 8, Rīga, LV-1063

2 Institute of Solid State Physics, Kengaraga 8, Rīga, LV-1063

In previous research [1] we developed LED based anomaloscope [2]. Pulse width modulation technique was used to control LEDs brightness with computer controlled microcontroller. It is possible to control up to 6 LEDs at same time with different PMW (pulse width modulation) frequencies simultaneously. We were able to correctly classify [3] persons with color vision deficiencies. Developed device prototype identified color matching range for trichromatic vision is 103 to 171 units on red-green scale. Normal color vision patients make consistent matches in specified region. Additional accessories like interference filters could improve the spectral characteristics of device, but will increase the expenses.

Figure 1
Fig. 1. Matching ranges were $9 \pm 1$ units with deviation 4 units. Industrially produced anomaloscopes red green scale are from 0 to 73 and matching range from 42 to 44 units on red green scale. If we compare scales proportionally that 89% of our patients matching ranges fit in normal matching range [1].

Experimenting with LEDs we find that increasing PWN frequency linearly increases brightness [1] also LEDs spectrum shifts toward to right side of CIE color diagram. We measured red, green, blue and yellow LEDs spectrum at 17 different PWM frequencies from 15 to 255 and calculated color we would perceive. As expected, specific cone response significantly decreased increasing pulse frequency, except yellow LED. This is due to red and green cones are almost equally aroused by yellow LED. However increasing PWM frequency to red LED, long wavelength cone response maintain constant, while blue and green cone responses decreased. In all cases LEDs emitted light shifted towards to right up to 35 nm; yellow -15 nm, green 5 -10 nm, blue - 15 nm, red - 35 nm. Increase of PWM frequency results in more intense saturation of LEDs color.

In further research our aim is to determine whether brightness distribution (wave form) change in time have impact on psychophysical response. There is plausible information that sensitivity on OFF - sawtooth stimuli are greater than ON- sawtooth stimuli[4]. Theoretical assumptions enable chance that there is brightness distribution to what our visual system is more sensitive than other wave forms. Our hypothesis is that such wave forms would help to increase the specificity of anomaloscope match and link color vision phenotype with existing genetic model.


[1] Trukša, R., Fomins, S., Ozoliņš, M. Rayleigh Equation Anomaloscope from Commercially Available LEDs.

[2] Woods, R. L, Rashed, A. L, Benavides, J. M, Webb, R. H. A Low-power, LED-based, High-brightness Anomaloscope Vision Research, 46 2005: pp. 3775 3781.

[3] Birch, J. Diagnosis of Defective Colour Vision. Oxford University Press, 1993: pp. 58 59.

[4] P.J., Demarco, V.C., Smith, J., Pokorny. (1993). Effects of sawtooth polarity on chromatic and luminance detection. Visual Neuroscience. Vol. 11. pp: 491-499.