INVESTIGATION OF TLBR PHOTOELECTRIC PROPERTIES OVER WIDE TEMPERATURE RANGE

Vytautas Janonis1

1 Institute of Applied Research, Vilnius University, Saulėtekio Ave. 9-III, LT-10222, Vilnius, Lithuania

Thallium bromide is a very promising material for the fabrication of low noise, high resolution X-ray and $\gamma$-ray detectors, which could be used at room temperature. Main properties of thallium bromide, important for production of good quality detectors are its wide band gap (2.68 eV), high density (7.56 g/cm3) and high atomic numbers (Tl: 81 and Br: 35). These properties ensure high photon stopping efficiency, which is required for a sensitive detector. Main problems in using TlBr detectors are caused by the high quality of required material, also by the degradation resulting from ionic conductivity within the crystal. Moreover, thallium bromide is hygroscopic and toxic, therefore cannot be left in a room environment. [1, 2]

The aim of this research was to investigate photoelectrical properties and surface topography of two thallium bromide samples. Dark and photocurrent current - voltage dependencies also thermally stimulated currents were investigated at different temperatures from 20 to 300 K. Photoconductivity spectra were measured at 20 K temperature.

Surface topography was measured, using optical and atomic force microscopes. Sample with best surface processing was identified. Also the effect of surface processing on electrical properties of the samples was identified in the research.

After investigating dark current - voltage characteristics at different temperatures ohmic behavior was confirmed, therefore it was stated that processes associated with contacts were negligible. While investigating photo-current - voltage characteristics space charge limited currents were observed due to large charge photo-excitation.

Temperature dependencies of the dark current and thermally stimulated current (TSC) were measured. Several peaks were identified in each samples TSC measurements. Charge-trapping level energies were calculated and effect of surface processing identified.

After measuring photoconductivity spectra, at 20 K temperature, several defect levels with different ionization energies were identified in each sample which led to conclusion that samples had different types of impurities which were caused by the methods which manufacturers used for growing and purifying the samples. After investigating relative defect peak height values and specific electric sample resistance values, sample with better crystalline quality was identified.


[1] Kažukauskas, V., Jurgilaitis, A., Vaitkus, J., Gostilo, V. & Shorohov, M. Photoelectrical Phenomena and Current Kinetics in TlBr. Mat. Sci. 14, 5-8 (2008).

[2] Kozlov, V. TlBr raw material purification, crystal growth, annealing, detector fabrication and characterisation for gamma-ray detector applications PhD Doctoral Thesis, University of Helsinki (2010).