MICRO-FIGURES CUTTING IN MOLYBDENUM FOIL USING A FEMTOSECOND PULSE LASER

Tomas Puodžiūnas1, Lina Mažulė1, Ignas Reklaitis2, Domas Paipulas1, Valdas Sirutkaitis1, Rolandas Tomašiūnas2

1 Laser Research Center, Vilnius University, Sauletekio ave. 10, LT-10223 Vilnius, Lithuania

2 Institute of Applied Research, Vilnius University, Sauletekio ave. 10, LT-10223 Vilnius, Lithuania

Femtosecond lasers provide us the ability to process materials with great precision. Because of the short pulse duration we can get smoother and cleaner side walls compared to picosecond and nanosecond lasers [1]. These advantages can be used for laser processing in semiconductor technology particularly for the fabrication of mask for ohmic contacts.

Molybdenum is used in semiconductor technology for its high melting point and one of the lowest coefficients of thermal expansion among commercially used metals. These qualities lead Mo to be the best choice for this particular technology. [2]

Figure 1
Fig. 1. Figures cut with different techniques and different parameters. Left image was operated using 0,02 W energy, 25kHz repetition rate and cutting speed of 1mm/s. Right one uses same options but different cutting technique – material ablation before cutting the particular figure.

We present experimental results on micro-fabricated figures in a Molybdenum foil using 280 fs pulse high repetition rate Yb:KGW laser (central wavelength 1030 nm). The aspheric lens (F=4.03 mm and NA=0.62) was used to focus the laser beam on the molybdenum foil surface. The beam diameter on the surface of the foil was 1.7 μm. The optimal micro-fabrication parameters (the speed of the cutting, pulse energy and repetition rate) were evaluated for cutting of square and circle figures in 30 μm thickness Molybdenum foil. The squares and circles with sub-10×10 μm size were fabricated.


[1] R. Moser, M. Kunzer, C. Goßler, Laser processing of GaN-based LEDs with ultraviolet picosecond laser pulses (Laser Sources and Applications, Proc. of SPIE Vol. 8433, 2012).

[2] X. Zhu, A.Yu. Naumov, D.M. Villeneuve, P.B. Corkum, Influence of laser parameters andmaterial properties onmicro drilling with femtosecond laser pulses (Appl. Phys. A 69 [Suppl.], S367–S371 (1999)).