The sol-gel process is a method to obtain ceramic materials through the condensation in solution of metallo-organics precursors, the condensation of the sol in a gel. In essence, the process begins by hydrolysis and polycondensation of precursors in solution, using a suitable catalyst, to form a colloidal suspension of nanometer scale particles. This sol is then coated onto a surface or cast into a mould, after which further condensation produce a rigid network. Therefore, in the least several decades, sol-gel techniques have been used to prepare variety mixed-metal oxides. In these sol-gel processes, good quality of the oxide products was expected primarily due to the purity of the precursor materials used and chemical homogeneity obtained from the synthesis route [1].
By definition, a sol is a suspension of colloidal particles in a liquid. A sol differs from a solution in that a solution is a single-phase system, whereas a sol is a two-phase, solid-liquid system. Colloidal particles can be in the approximate size range of 1-1000 nm, hence gravitational forces on these particles are negligible and interactions are dominated by short-range forces, such as van der Waals and surface charges. Brownian motion leads to a low energy arrangement, thus imparting stability to the system. If a three dimensional network of the formerly dispersed colloidal particles is formed, the structure is called a gel. Removal of the liquid phase results in the formation of xerogels, which only consist of the solids structure.
The sol can be produced starting both from organic or inorganic precursors, which consist of a metal or metalloid element surrounded by various organic ligands and the whole process is conducted at room temperature. The peculiar thing is that the solid state can be reached at low temperature starting from a solution, and this fact expands greatly the possibility to create new materials or to improve their properties [2].
The technological applications of the sol-gel technique range in a very wide field, because of the versatility and simplicity of the method. The possible applications derive from the various shapes that can be obtained from the gel state and from the compositional and microstructural control of the process, combined with the low processing temperature.
The reason of searching new sol-gel synthesis ways in order to reduce the cost and toxicity of preparation technique also is very desirable. One of the best solutions of these problems is employing the water instead of organic solvents during the main sol-gel synthesis step. As a result aqueous sol-gel synthesis method also could be successfully applied for the preparation of different ceramic compounds. So, this aqueous sol-gel technique is really attractive and compared to other techniques, as it has the advantages of a good control of the starting materials and of the processing parameters, a high purity of the raw materials, and the low temperature of the process [3].
Thus, in this oral presentation we show the aqueous sol-gel synthesis of different molybdates and tungstates combined with alkaline earth metals and different lanthanides. The all obtained samples were characterized by X-ray diffraction (XRD) analysis, scanning electron microscopy (SEM) and UV-Vis spectroscopy. Moreover, the investigation of the influence of two complexing agents, namely tartaric and citric acids, and slightly different starting materials on the characteristics of final oxides was also performed.