SOL-GEL SYNTHESIS, CRYSTAL STRUCTURE, SURFACE MORPHOLOGY, AND FT-IR SPECTROSCOPICAL INVESTIGATION OF ALKALINE-EARTH METAL MOLYBDATES

Gediminas Braziulis1, Giedrė Gaidamavičienė1, Artūras Žalga1

1 Faculty of Chemistry and Geosciences, Vilnius University, Naugarduko Str. 24, 03225 Vilnius, Lithuania

Among various metal oxides, molybdates play a key role in potential and technological applications such as optic fibers, humidity sensors, catalysts, scintillation detectors, solid-state lasers, photoluminescent devices, microwave applications and so on [1, 2].

From the structural point, the differences between alkaline earth metal molybdates (AMoO4, A = Mg, Ca, Sr, and Ba) mainly consist in ionic radius of the A-site. If the ionic radius of the A-site ion is smaller than 1.0 Å as is the case for MgMoO4 ceramic, the compounds show a wolframite structure with octahedral coordination. Alternatively, if the ionic radius of the A-site is larger than 1.0 Å as is the case for Ca2+, Sr2+, and Ba2+ in AMoO4, the compounds show a scheelite structure with tetrahedral coordination [3].

Up to now, various techniques have been developed to synthesize molybdates, such as traditional solid-state reaction, the coprecipitation synthesis, the combustion method, Czochralski method, solvothermal process, reverse micellar reaction, microwave irradiation, spray pyrolysis, the facile microemulsion-mediated hydrothermal process, electrochemical method, sonochemical preparation and sol-gel synthesis. Among these different synthesis routes the solution based synthetic methods play a crucial role in the design and production of fine ceramics and have been successful in overcoming many of the limitation of the traditional solidstate, high-temperature methods [4]. Such kind synthesis techniques can eliminate major problems, such as long diffusion paths, impurities, and agglomeration, and result in products with improved homogeneity. Moreover, the sintering temperature that usually strong affects the properties of final compounds is crucial factor for the preparation of both nano-sized materials and thin films on different substrates [3–5].

In this work, the samples MMoO4 (where M = Mg, Ca, Sr, and Ba) were successfully prepared by an aqueous sol–gel synthesis route taking tartaric acid (TA) as a ligand in order to prevent the crystallization and precipitation of both the initial and final compounds during the sol–gel processing. Afterwards, M–Mo–O tartrate gel precursors were additionally annealed at 500, 600, 700, 800, 900, and 1000 °C temperatures and investigated by X-Ray diffraction (XRD), scanning electron microscopy (SEM), and Furier Transform infrared spectroscopy (FT-IR). According to the XRD results is clear that the crystallization of final compound starts below 500 °C in all cases except for BaMoO4. It is obvious that the formation of barium molybdate really depends on the synthesis conditions (pH, temperature, mixing rate and etc.) during the sol–gel processing. SEM measurements revealed that by increasing annealing temperature the size of the particles also tends to increase. Besides, the results obtained from FT–IR spectra of investigated samples showed that there exist the relation of changes between the surface morphology and appearance of submitted curves.


[1] M. G. Amini, M. Bazarganipour, M. S. Niasari, Calcium molybdate octahedral nanostructures, hierarchical self-assemblies controllable synthesis by coprecipitation method: Characterization and optical properties, Journal of Industrial and Engineering Chemistry 21, 1089–1097 (2015).

[2] Y. Wang, L. Yang, Y. Wang, X. Wang and G. Han, Controlled synthesis of CaMoO4 and SrMoO4 rods by a simple sonochemical method, Journal of the Ceramic Society of Japan 120, [9] 378-381 (2012).

[3] G. Braziulis, R. Stankeviciute, A. Zalga, Sol-gel Derived Europium Doped CaMoO4:Eu3+ with Complex Microstructural and Optical Properties, Materials Science-Medziagotyra 20 [1] 90-96 (2014).

[4] G. Braziulis, G. Janulevicius, R. Stankeviciute, A. Zalga, Aqueous sol-gel synthesis and thermoanalytical study of the alkaline earth molybdate precursors, Journal of Thermal Analysis and Calorimetry 118 [2], 613-621 (2014).

[5] A. Zalga, A. Kareiva, A. Zarkov, S. Tautkus, B. Abakeviciene, UV-Vis spectroscopical investigations of the YSZ thin films on corundum, silicon and silica substrates, Chemija 25 [1], 29-33 (2014).