Here we present the preliminary mission analysis for the ESTCube-2 three-unit CubeSat, which is designed to test the Coulomb drag propulsion. One of the applications of Coulomb drag is the electric solar wind sail (E-sail) that could be used to travel within the Solar System with record speeds due to the solar wind. Another application is deploying a charged tether in low Earth orbit to brake the orbital velocity of the satellite using Coulomb drag. The negatively charged plasma brake tether interacts with the ambient ionospheric plasma ram flow to slow down the satellite.
To test this concept, ESTCube-2 will deploy and charge nominally 300 m tether, which will be used to reduce the orbit altitude of the satellite. Such a tether could deorbit ESTCube-2 from the altitude of 700 km to 500 km in half a year. The experience with ESTCube-1 and Aalto-1 has shown that it is feasible to host a similar payload in ½ to ½ of a CubeSat unit. The mass of 300 m long tether is nominally 30 grams according to a conservative estimate. Hence the plasma brake is a lightweight, efficient, cost-effective and scalable deorbiting system with a potential to address the space debris problems in the most critical altitudes of 900 km and less.
ESTCube-2 in-orbit demonstration platform will be designed and developed such that it can be employed for other Coulomb drag propulsion experiments. For example, by demonstrating the electric solar wind sail (E-sail) outside the Earth's magnetosphere which would allow to confirm the analytical, numerical and laboratory estimations of the E-sail force. The main requirements for the satellite bus are to provide the total angular momentum of 23 Nms for centrifugal tether deployment, to provide means of deployment verification, and to provide up to 3000 mW of power for charging the tether. This paper will present mission analysis and system level design of ESTCube-2.