Organic light emitting diodes (OLEDs) with five different chinoline derivatives using tetrazole and iminophosphorane substituents were prepared using thermal vacuum evaporation technology. These materials were synthesized in Vilnius University Faculty of Chemistry and worked as an emission layer in a structure of layers formed on a glass/ITO substrate. Structure consisted of anode (ITO), hole transfer layer (TPD), emission layer (chinoline derivatives with tetrazole and iminophosphorane substituents), hole blocking layer (TmPyPB), electron transporting layer (Alq3) and cathode (LiF/Al). Energy values of HOMO (Highest Occupied Molecular Orbital) and LUMO (Lowest Unoccupied Molecular Orbital) for newly synthesized organic materials were taken from the article [1]. The other HOMO and LUMO values were taken from literature [2-5].
After formation of OLEDs with the structure mentioned above, examination of photoelectric properties followed. Photoluminescence and electroluminescence spectra were measured using AvaSpec spectrometer. Electroluminescence was noticed in OLEDs starting with 9V threshold voltage. Measurements showed that EL was obtained in 400 nm and 600 nm wavelength range.
Photoluminescence spectra were measured upon excitation at 369 nm using UV light. In all OLEDs PL spectra had few peaks in range of 400 nm to 600 nm.
We have also measured Volt-Ampere Characteristic (j-V) of OLEDs in which double injection regime was noticed. Due to structural defects in some emissive chinoline derivative layers multicrystaline OLED structures were formed. As a result, EL was not observed in these OLEDs.
In summary, small peculiarities in the chemical structure of the substituent in chinoline derivatives can cause not only spectral PL and EL emission changes but also structural defects in the OLED structure.