PECULARITIES OF 238Pu AND 239,240Pu ASSESSMENT IN FRESH WATER SYSTEMS

Zita Žukauskaitė1, Benedikta Lukšienė1

1 State Research Institute Center for Physical Sciences and Technology, Savanorių ave. 231, LT-02300 Vilnius, Lithuania

Plutonium was deposited in the environment as a result of global fallout and releases from other nuclear activities during the past 70 years. Among 20 isotopes of Pu with mass numbers from 228 to 247 the most studied isotopes of plutonium in the environment are 238Pu (87.7 yr), 239Pu (24110 yr), 240Pu (6563 yr) and 241Pu (14.4 yr), among which 239Pu and 240Pu are the most important ones due to their long half-lives and relatively high abundance. Besides, the atomic ratios of 240Pu/239Pu varying with release conditions of Pu and the type or design of the device can serve as a finger print for tracing the source of plutonium contamination [1].

Measurements of plutonium in fresh water require a very large volume of water sample (300-500 L) due to a very low concentration of plutonium. Plutonium analysis consists of several main stages: pre-concentration, separation, purification, electrodeposition and alpha spectrometric measurement.

Pre-concentration of radionuclides prior to their determination is necessary to avoid difficulties associated with their detection [2]. Radionuclides from large volume of water might be pre-concentrated using chemical precipitation, evaporation, adsorption onto various sorbents.

There is a wide variability of materials, whose sorption capability of removing heavy metals and radionuclides from large volume water samples is investigated [3, 4]. Bentonite [5], mesoporous silica functionalized with copper ferrocyanide [6], zeolite, montmorillonite, aerogel, silica gel [7], hydrous oxides of Mn, Al, Mg and Fe [2], microbial and seaweed biomass (living or dead), cellular products, activated carbons, sewage sludges, clays and clay-like minerals, hybrid materials and ordered mesoporous silica [8] are used as sorbents. Biomaterials such as moss, lichens, pine needles, peat, saw dust, fly ash, etc. can also be used as sorbents. Chemical precipitation can be caried out using multi-stage precipitation with FeCl3, Nd2O3 and KMnO4. The plutonium content is precipitated together with the Fe(OH)3, NdF3 and MnO2 precipitates.

The easiest and shortest way of plutonium pre-concentration is sorption on various sorbents. It might take from several minutes to one day, compared with chemical precipitation (4-5 days) and evaporation using a water bath (1-2 months).

The aim of this work is to compare a few methods to pre-concentrate plutonium from a large volume of water samples.

The obtained results showed that the easiest way of plutonium pre-concentration was sorption on sorbents. Chemical precipitation carried out using FeCl3 (pH=2) was compared with sorption on sorbent – moss. Results showed that sorption on moss could be used as a cheaper and faster way of the sample pre-concentration method – the obtained 239,240Pu values by compared methods were close to each other.


[1] X.L. Hou, P. Roos, Critical Comparison of radiometric and mass spectrometric methods for the determination of radionuclides in environmental, biological and nuclear waste samples, Analytica Chimica Acta 608 105-139 (2008).

[2] G. Koulouris, B. Slowikowski et al., Pre-concentration of actinoids from waters: a comparison of various sorbents, Applied Radiation and Isotopes 53, 279-287 (2000).

[3] Li Ping, Yin Zhuoxin et al., The immobilization of U (VI) on iron oxyhydroxides under various physicochemical conditions, Environmental Science.: Processes Impacts 16, 2278-2287 (2014).

[4] F.E. Soetaredjo, A.Kurniawan et al., Investigation of the continuous flow sorption of heavy metals in a biomass-packed column: revisiting the Thomas design model for correlation of binary component systems. RSC Adv., 4, 52856-52870 (2014).

[5] J. D. Begg, M. Zavarin, S. J. Tumey, A. B. Kersting, Plutonium sorption and desorption behavior on bentonite, Journal of Environmental Radioactivity 141, 106-114 (2015).

[6] T. Sangvanich, V. Sukwarotwatb, R. J. Wiacek et al., Selective capture of cesium and thallium from natural waters and simulated wastes with copper ferrocyanide functionalized mesoporous silica, Journal of Hazardous Materials 182, 225-231 (2010).

[7] S. Shaban, V. Mikulaj, Sorption-desorption of radiocesium on various sorbents in presence of humic acid, Journal of Radioanalytical and Nuclear Chemistry 208(2), 593-603 (1996).

[8] F.E. Soetaredjo, A. Kurniawan, L.K. Ong, D.R. Widagdyo, S. Ismadji, Investigation of the continuous flow sorption of heavy metals in a biomass-packed column: revisiting the Thomas design model for correlation of binary component systems RSC Adv. 4, 52856-52870 (2014).