FUNCTIONALIZED GRAPHENE OXIDE AND ITS APPLICATION IN RAPESSEED OIL TRANSESTERIFICATION REACTION

Justina Gaidukevič1, Jurgis Barkauskas1, Paulina Rechnia2, Aleksandra Miklaszewska2, Mieczysław Kozłowski2

1 Department of Inorganic Chemistry, Vilnius University, Lithuania

2 Faculty of Chemistry, Adam Mickiewicz University in Poznań, Poland

As the fossil fuels are depleting progressively, there is a need to find an alternative fuel to fulfill the energy demand of the world. One of the most promising propositions is biodiesel, which is defined as a mixture of mono-alkyl esters of long chain fatty acids (FAME), produced by the transesterification of vegetable oils with an alcohol in the presence of a homogeneous catalyst (NaOH or H2SO4) [1]. However, the use of such substances may cause corrosion and environmental problems, moreover, these catalysts are not recoverable and require more expensive equipment. Additionally, while these catalysts are partly soluble in the reaction mixture, the separation and purification of products become a more difficult task [2]. A solution of those problems could be the application of heterogeneous catalysts, e.g. modified carbon materials. In comparison with the conventional catalysts, carbon materials have many advantages: they are biocompatible, inexpensive, stable, environmentally friendly and readily available. Different carbon materials, including carbon black, activated carbon, carbon nanotubes and graphene, have been used as the effective catalysts or catalyst supports [3]. Amongst the carbon materials described above, graphene has recently gained some serious attention, as it has extraordinary properties, including high specific surface area (2630 m2/g), good chemical stability, remarkable electrical, thermal and mechanical properties and it is an ideal platform to attach various functional groups. Accordingly, a derivative of graphene - graphene oxide (GO), offers a wide range of possibilities to synthesize the novel functional catalysts due to the abundant oxygen-containing functional groups on its basal planes (hydroxyl and epoxy groups) and edges (carboxylic groups) [4].

The aim of this work was to produce functionalized graphene oxide catalysts with acidic or basic sites on their surface and to investigate their catalytic activity in the transesterification reaction of rapeseed oil with methanol.

The graphite oxide (GrO) was prepared from the natural graphite by the protocol reported by Yan et al. [5]. In a typical experiment, graphite powder was treated with conc. H2SO4, K2S2O8 and P2O5. Later, this pre-oxidized graphite was subjected to oxidation by Hummers method using NaNO3, H2SO4 and KMnO4 [6]. GO nanosheets were generated when GrO powder was dispersed in water with ultrasonic vibration under 25 kHz for 15 h. Finally, the GO suspension was dried at 100 °C to obtain the GO powder. To introduce acidic sites on GO surface, different sulphonation protocols with 4-aminobenzenesulphonic acid were applied [7, 8]. To introduce basic sites, GO was modified with 3-(N,N'-dicyclohexylguanidine)-propyltrimethoxysilane (GPMS) [9] or 1,5,7-triazabicyclo [4.4.0] dec-5-ene (TBD) as described in [10, 11]. The obtained catalysts were characterized by different methods (TG and elemental analysis, BET measurements, potentiometric titration and SEM investigations). The transesterification reaction of rapeseed oil with methanol was carried out at the temperature of 130 °C under 1.3 MPa for 24 h. During the reaction four samples of the reaction mixture were collected (after 1, 3, 6 and 24 hours). The SRI 8610C gas chromatograph was used to determine the content of FAME in the post-reaction mixture.

The results show that acidic catalysts were more active in the transesterification reaction of rapeseed oil with methanol than basic ones. The best results were obtained using GO, which was modified by SOCl2 and 4-aminobenzenesulphonic acid. The content of FAME after 24 hours was equal to 63 %. In the conditions used, this catalyst was more active than the commercial Amberlyst 15.


[1] I. M. Atadashi, M. K. Aroua, A. R. Abdul Aziz, N. M. N. Sulaiman, The effects of catalysts in biodiesel production: A review, J. Ind. Eng. Chem. 19 (1), 14–26 (2013).

[2] K. Narasimharao, A. F. Lee, K. Wilson, Catalysts in production of biodiesel: a review, J. Biobased Mater. Bioenergy 1 (3), 301–314 (2007).

[3] L. J. Konwar, J. Boro, and D. Deka, Review on latest developments in biodiesel production using carbon-based catalysts, Renew. Sustain. Energy Rev. 29, 546–564 (2014).

[4] D. R. Dreyer, S. Park, C. W. Bielawski, R. S. Ruoff, The chemistry of graphene oxide, Chem. Soc. Rev. 39 (1), 228–240 (2010).

[5] X. Yan, J. Chen, J. Yang, Q. Xue, P. Miele, Fabrication of free-standing, electrochemically active, and biocompatible graphene oxide-polyaniline and graphene-polyaniline hybrid papers, ACS Appl. Mater. Interfaces 2 (9), 2521–9 (2010).

[6] J. William S. Hummers, R. E. Offeman, Preparation of Graphitic Oxide, J. Am. Chem. Soc. 80, 1339 (1958).

[7] M. Toupin, D. Bélanger, Spontaneous functionalization of carbon black by reaction with 4 nitrophenyldiazonium cations, Langmuir 24 (12),1910–1917 (2008).

[8] V. Sadhu, N. a Nismy, D. T. Adikaari, S. J. Henley, M. Shkunov, S. R. P. Silva, The incorporation of mono- and bi-functionalized multiwall carbon nanotubes in organic photovoltaic cells, Nanotechnology 22, 265 (2011).

[9] J. M. Balbino, E. W. de Menezes, E. V. Benvenutti, R. Cataluna, G. Ebeling, J. Dupont, Silica-supported guanidine catalyst for continuous flow biodiesel production, Green Chem. 13, 3111 (2011).

[10] P. Kalita, R. Kumar, Immobilization of 1,5,7-triazabicyclo [4.4.0] dec-5-ene over mesoporous materials: An efficient catalyst for Michael-addition reactions under solvent-free condition, Applied Catalysis A: General 397, 250–258 (2011).

[11] S. B. Muazu, A.Farook, The chemical fixation of carbon dioxide to propylene carbonate over triazabicyclodecenefunctionalized silica nano catalyst, International Journal of Scientific & Engineering Research 5, 1045-1056 (2014).