Plutonium isotopes are present in the environment as a result of nuclear weapon testing, nuclear fuel reprocessing and nuclear facility accidents. Much attention has been paid to the evaluation of radiation risk of Pu in the environment due to its strong radiological toxicity and long-term persistence [1]. Dissolved radionuclide ions bind to solid surface because of a number of processes often classified under the broad term of sorption. Although a significant progress has been made in describing sorption on heterogeneous solids as a weighted result of sorption on the homogeneous surface, models for describing the radionuclide sorption are still mostly based on empirical values of solid-liquid distribution coefficients ($K_d$, L·kg-1). This is the simplest sorption model and consists of the ratio of the concentration of the radionuclide sorbed on a specific solid of the radionuclide in a specified liquid phase at equilibrium.
The distribution coefficient $K_d$ is one of the most significant parameters in predicting the fate of a radionuclide in the environment, it is a common input in risk assessment models. Some efforts have been made to create a $K_d$ database for soils and to establish ranges of values for a specific radionuclide and soil type and its features [2]. The $K_d$ value was calculated using the following equation:
$$K_d = \frac{(C_i - C_e)}{C_e} \cdot \frac{W_l}{W_s} \tag{1}$$Where $C_i$ is the initial radionuclide concentration (BqL-1), $C_e$ is the radionuclide equilibrium concentration in the liquid phase (Bq L-1), $W_l$ is the solution volume (L) and $W_s$ is the soil dry weight (kg) [3].
To determine empirical values of the solid-liquid distribution coefficient of 236Pu, we conducted laboratory experiments with loam, clay, peat and two types of sand samples (sand BLZ and sand BDG). The amount of organic matter, micro and macro elements (Cu, Mn, Co, Pb, Fe, Ca, Mg, K) and total density were determined in all soil samples. Sand samples contained different concentrations of tested elements, where of different color and texture, also had different pHKCl values. The dynamic flow method was used in the investigation of the sorption and transport of plutonium (236Pu) in soils from distilled water. The 236Pu uptake from aquatic medium by tested soils was evaluated following radiochemical analysis of the sorbent and effluent. The plutonium analyte of each studied aliquot was electrochemically deposited onto the stainless steel disc and measured with the alpha spectrometer.
Calculated $K_d$ values showed the different permeability of tested soils to 236Pu from distilled water of pH 1.6. According to $K_d$ values tested soil samples may be distributed in the following sequence: peat> clay> loam> sand BLZ>sand BDG. It can be concluded that the amount of principal macroelements, Ca and Mg, basically defines the magnitude of the $K_d$ value under tested conditions. The higher the amount of these elements in the soil, the higher value of the solid-liquid coefficient $K_d$. The differentiation in $K_d$ values was observable depending on the amount of Ca and Mg in sand samples. The Ca and Mg concentration in sand BLZ was 8.5 mg·g-1 and 1.25 mg·g-1, respectively, and the solid-liquid distribution coefficient $K_d$ value was 292.0 L·kg-1. The Ca amount was above the determination limit and Mg concentration was 0.25 mg·g-1 in the sand BDG. The solid-liquid coefficient $K_d$ value was significantly lower in the sand BDG compared to that in sand BLZ, it was only 54.6 L·kg-1. Obviously $K_d$ values in sand samples demonstrated the feature of probably high accumulation capacity of Ca and Mg compounds present in soil.