FABRICATION AND INVESTIGATION OF LAMINATED SOLUTION-BASED NON-FULLERENE ORGANIC SOLAR CELLS

Rokas Jasiūnas1

1 Department of Physics, Chemistry and Biology, Linköping University, Sweden

As demand for cheap and environmental friendly energy is expected to increase more and more in following decades both industry and academia are on a quest to produce technology as a supply for this demand. Organic Photovoltaic (OPV) is one of most promising candidate for such demand owing to its possibility of extremely low-cost solution-based production. Here we present highly attractive fabrication process of laminated all-polymer solar cells on flexible and transparent plastic substrate having both electrodes and active layer deposited from solutions. As well results of brief charge carrier migration investigation in fabricated bilayer solar cells.

We were able to laminate devices with active layer as thin as 40 nm and made several sets of devices with thickness varying up to 400 nm. Even though cells were made in bilayer structure best Power Conversion Efficiency (PCE) reached over 1% and is comparable with conventional and more efficient bulk heterojunction structure with evaporated aluminum cathode for the same active layer materials. Exposure to oxygen was minimized after printing electrodes in ambient conditions, but was not completely avoided, which contributed to poor reproducibility of devices. Nevertheless, all different device sets showed familiar tendencies in performance.

We were able to probe Charge Transfer (CT) states at bilayers interface by investigating electroluminescence spectrum. We observed CT states red-shift with increasing active layer thickness, which we attribute to thermalization of injected charge carrier migrating from electrode to donor-acceptor interface.