THERMOANALYTICAL AND STRUCTURAL STUDIES ON ALKALINE EARTH METALS SUBSTITUTED La2Mo2O9 MATERIALS

Giedrė Gaidamavičienė1, Tomas Murauskas1, Artūras Žalga1

1 Faculty of Chemistry and Geosciences, Institute of Chemistry, Vilnius University, Naugarduko Str. 24, LT-03225 Vilnius, Lithuania

Ionic conductors have been attracting considerable attention since they were discovered by Faraday over 200 years ago. Devices such as the solid oxide fuel cell (SOFC) take an interest as the critical step in hydrogen economy. To be technologically viable these oxide electrolytes must exhibit high oxide-ion mobility and low operating temperatures [1-3]. Since Laccore at el. reported La2Mo2O9 high ionic conductivity, it has attracted much attention because of its potential application as solid electrolyte (0.06 S/cm at 1073 K) [2].

La2Mo2O9 exists in two different crystallographic modifications: monoclinic α phase (P21) that occurs at room temperature with a very low conductivity and cubic β phase (P213), which is stabile above 853 K. After phase transition the anionic conductivity increases sharply by two orders of magnitude. In order to stabilize β-phase of the lanthanum molybdate in low temperatures, K+, Sr2+, Ba2+, Ca2+, Bi3+, V5+, S6+, Cr6+, W6+ and other ions can be used to suppress the phase transition to the α-phase. The substitution with lower valence cation (Ca2+, Sr2+) could stabilize the cubic structure of β-phase and increase oxygen-vacancy concentration. This action may lead to higher ionic conductivity and better stability of final ceramic [4-6].

Moreover, it is well-known that transport properties strongly depend on the preparation methods, which are used for the synthesis of polycrystalline powders. Negative effect of these properties can be caused by porosity, impurities and low connectivity between the grains [7], which usually occurs using traditional synthesis technique like solid-state reaction. Meanwhile, using aqueous sol-gel synthesis it is possible both to avoid the limitations described above, and to enhance homogeneity, purity and density of the final ceramics. This method also allows to synthesize different ceramic materials in relatively low temperatures. Besides, using this technology, chemical reaction takes place either in an atomic or molecular levels and long diffusion paths is not necessary. Furthermore, in the sol-gel process using tartaric acid as a ligand it is possible to reduce interactions between the individual components, thus avoiding the formation of precipitates during the gelation process.

In this study, we report environmentally benign and simple method, which is successfully applied for the synthesis of La2-xMxMo2O9-y (where, M = Ca and Sr). Besides, in order to investigate both the thermal decomposition of La-M-Mo-O tartrate gel precursors and crystallization temperature of the final double oxide the thermogravimetric analysis and differential scanning calorimetry (TGA-DSC) were performed. The obtained results clearly showed that calcium and strontium doping in the lanthanum site stabilizes cubic β phase of La2Mo2O9 at room temperature and no phase transition from meta-stable cubic phase to monoclinic was observed. Additionally, all synthesized materials were analyzed by X-Ray diffraction (XRD) analysis and Raman spectroscopy in order to show the highest doping amount of alkaline earth metal in lanthanum molybdate without secondary phase formation. Furthermore, the morphology of different doped ceramics were investigated by scanning electron microscopy (SEM), which revealed the dense surface formation with individual μm sized particles of the samples sintered at 1473 K of temperature.


[1] S. J. Skinner and J. A. Kilner, Oxygen ion conductors, Materials Today, 6, 30-37 (2003).

[2] P. Lacorre, F. Goutenoire, O. Bohnke, R. Retoux and Y. Laligant, Designing fast oxide-ion conductors based on La2Mo2O9, Nature, 404, 856-858 (2000).

[3] S. Basu, P. Sujatha Devi, and H. S. Maiti, Nb-Doped La2Mo2O9: A New Material with High Ionic Conductivity, Journal of The Electrochemical Society, 152, A2143-A2147 (2005).

[4] A. Khaled, J. J. Pireaux and S. Khelili, Synthesis and Characterization of Ca and Ba Doped LAMOX Materials and Surface Study by X-ray Photoelectron Spectroscopy, Acta Chimica Slovenica, 59, 766-778 (2012).

[5] A. Kežionis, D. Petrulionis, E. Kazakevičius, S. Kazlauskas, A. Žalga, R. Juškėnas, Charge carrier relaxation phenomena and phase transition in La2Mo2O9 ceramics investigated by broadband impedance spectroscopy, Electrochimica Acta, 213, 306-313 (2016).

[6] Santanu Basu, P.Sujatha Devi, N.R. Bandyopadhyay, Sintering and densification behavior of pure and alkaline earth (Ba2+, Sr2+ and Ca2+) substituted La2Mo2O9, Journal of the European Ceramic Society, 33, 79-85 (2013).

[7] D. Marrero-López, J. Pena-Martinez, D. Pérez-Coll and P. Nunez, Effects of preparation method on the microstructure and transport properties of La2Mo2O9 based materials, Journal of alloys and compounds, 422, 249-257 (2006).