FORMATION OF COPPER SULPHIDES ON POLYPROPYLENE MATRIX USING VARIOUS REDUCING AGENTS

Kamilė Vonžodaitė1, Eglė Balčiūnaitė1, Rasa Alaburdaitė1, Edita Paluckienė1

1 Department of Physical and Inorganic Chemistry, Kaunas University of Technology, Lithuania

Copper sulphides mark a big variety of valuable physical properties. One of the most valuable physical properties that determine wide usage of these compounds is electrical conductivity. Depending on stoichiometric composition, these copper sulphides can be isolators, semiconductors, conductors, and superconductors. They are widely used in advanced technologies, like gas sensors, as polarizers of infrared radiation, galvanic and solar cells, catalysts and other.

Polypropylene (PP) is a chemically resistant, stiff constructive plastic, which is characterized by good dielectric properties. In comparison to other plastics it is one of the lightest and cheapest.

Usage of polymer films, coated with electroconductive layers, has been increasing in the past years due to their elasticity, resistance against corrosion, and low toxicity. Electrically conductive CuxS layers on polymers can be prepared by the sorption-diffusion method Error! Reference source not found.. By this method, the surface of a polymer is initially treated by a different sulphurization agent and, subsequently, aqueous Cu (I/II) salt solution.

The aim of this study was to form copper sulfide layers on polypropylene films and investigate their properties. The process of forming copper sulfide layers consisted of five stages: surface pre-treatment, oxidation, sulfurization, treatment with Cu(I/II) salt solution, and thermal treatment.

Firstly, PP films were cleaned with ethanol and acetone ultrasonically and were held in an oxidizing solution of KMnO4 for 2–4 h to enhance their adhesive properties [2]. Oxidized samples were sulfurized in an acidic solution of thiourea with ammonium persulfate additive for 1–5 h and treated with CuSO4, using hydroquinone or hydroxylammonium sulfate as a reducing agents. Finally, all samples were thermally treated in an electric oven. Formed copper sulfide layers were investigated by measuring electrical resistivity, using X-ray diffraction, UV spectroscopy, and contact angle measurements.

Based on the experimental' data, the highest UV absorption and the most intense color on the polypropylene film was observed for the samples that were treated with Cu(I-II) for the longest time. X-ray diffraction analysis has revealed that there are traces of CuxS and sulphur on the polypropylene films. Additionally, surface wettability changed depending on the treating stage.


[1] R. Alaburdaitė, E. Paluckienė, S. Grevys, Investigation of CuxS layers on polypropylene film formed by using different sulfuring agents, Chalcogenide Lett. 13(12), 529-536 (2016).

[2] J. Wang, Y. Zhu, Y. Fu, Fabrication and properties of KMnO4-treated functionalized biaxially oriented polypropylene (BOPP) films coated with a hybrid material, J Sol-Gel Sci Technol 71, 176-183 (2014).