Manufacturing of solid oxide fuel cell (SOFC) components nowadays remains a key point for the industrial development of this technology. Especially, the deposition of dense electrolyte layer which is sandwiched between the porous anode and cathode attracts a lot of attention [1]. Nevertheless, the practical application of these devices is hindered by the high operation temperature (up to 800 °C) required to allow the conduction of oxygen ions through conventional electrolytes (i.e., yttria-stabilized zirconia (YSZ)) [2]. Concerning the electrolyte production, a number of many different compositions have been found which present higher ionic conductivity than YSZ. The drawbacks such as lower stability under reducing conditions, undesired phase transformations or interaction with cathode or anode materials should be eliminated in order to replace YSZ by other electrolyte. The reducing of operating temperature also plays important role in the production of SOFC. Solid electrolytes that possess high conduction below 600 °C overcomes the YSZ. One of the most promising electrolyte that operates at low temperature is lanthanum molybdate with general formula La2Mo2O9 (LAMOX). This compound is well known for more than a decade because of its high ionic conductivity that increases up to two orders of magnitude during the reversible phase transition from monoclinic a to cubic β structure at about 560 °C and reaching conductivity higher than the one corresponding to YSZ. Despite lower chemical stability of LAMOX at high temperatures, comparing with YSZ, the possibility to increase the resistance to the environment conditions and to stabilize the high temperature cubic phase at room temperature with increased ionic conductivity is really attractive and desirable.
In this respect, the substitution of La by Ca (i.e., $La_{2-x}Ca_xMo_2O_{9-\delta}$) was reported to improve the stability against reduction of this kind of materials with a slight decrease of ionic conductivity and retaining the high temperature β-cubic phase. Moreover, it is well known that the size of the particles for standard practice powder usually reaches 50 μm to 100 μm in diameter. Accordingly to that in this work the aqueous sol-gel synthesis method was successfully used in order to obtain lanthanum molybdate substituted by calcium. In addition, the influence to the possible formation of final material according to the starting compounds by thermal analysis (TG/DSC) was investigated in detail. Besides, the surface morphology of annealed ceramic was analyzed by scanning electron microscopy (SEM) in order to prove the formation of dense structures. Finally, X-Ray diffraction (XRD) was used to assess the composition of the crystalline phases in the sample.