Despite the tremendous success of the Standard Model, there is no doubt that it cannot be a complete theory due to a numerous experimental evidences for which the SM fails to find an explanation. One part of these experimental evidences are the observation of neutrino oscillations (for a short review of these experiments see ref. [1]). This proves that at least two of the neutrinos have masses, but the original assumptions of the SM forbids these mass terms. This proves that the neutrino and (possibly) Higgs sectors should be extended with some new degrees of freedom (new particles), to allow for a possibility for neutrinos to have mass.
The simplest "building blocks" for a fermionic particle content are Weyl spinors. Thus the model building is usually done in Weyl spinor notation. However, nearly for all practical calculations the Dirac spinors are used. In chiral representation they are equivalent for two independent Weyl spinors. For the case of having one massive Weyl spinor in a theory, the formulation is done with implying a condition on the Dirac spinor to get a Majorana spinor. The main difference can be easily seen if you build these spinors from Weyl spinors:
$$\psi_D = \left( \begin{array}{c} \chi \ \xi^\dagger \end{array} \right) \, ; \psi_M = \left( \begin{array}{c} \chi \ \chi^\dagger \end{array} \right) \, $$where $\chi,\xi$ are Weyl spinors and $\psi_D, \psi_M$ are Dirac and Majorana spinors, respectively. In the SM, there is no difficulty to find this correspondence of formalisms from Weyl to Dirac, since all the particles that have mass come in pairs of Weyl spinors that have the same mass term generated by Higgs mechanism. The massless neutrino comes only in the electroweak interactions and has no coupling with the Higgs, so its treatment as a massless Majorana spinor doesn't give any complications as well. But when considering how to extend the SM with neutrino masses, the correspondence between these two formalisms becomes not so trivial.
Considering one family for simplicity, the easiest way to let the neutrino have a mass is to postulate an additional neutral Weyl spinor that can interact with a SM neutrino and the Higgs. Its neutrality allows it to have an additional mass term as well, that doesn't come from the Higgs mechanism. (When this additional mass term is taken to be large, it is called the seesaw mechanism of type I. For an overview of seesaw models see ref. [2]) Without the latter mass term, we could trivially write the neutrino as a Dirac spinor (just as the electron). Without the interaction between two spinors, we would have two uncoupled Weyl spinors that can be written as Majorana spinors, but the observed neutrino wouldn't have a mass and this additional particle couldn't be observed in principle. So for this extension we have something in between of pure Dirac and Majorana case. By going into mass eigenstate basis, we can mix these spinors to write them as two Majorana neutrinos, but of course, the relation is not so simple then. The analysis could prove to be simpler if the calculations would be held using Weyl spinors.
In this work we try to fill the mentioned gap between model building and practical calculations. Using the ref. [3], where this formulation for some SUSY calculations are presented, we concentrate on the seesaw extension of the SM. For simplicity, we take only one family, and develop techniques for analyzing seesaw neutrinos. For a consistent treatment of this formalism, we recheck notations using path integral formalism. Since the mass of the neutrino is related to its self energy, we do the one loop corrections for a propagator in general Rξ gauge and discuss the renormalization in the spirit of rescaling parameters.