Polytungstates and polymolybdates based either on rare earth metals (R = La, Nd, Dy, Sm, Gd etc. or alkali metals (Li, Na, K, etc.) have drawn significant attention in recent years because of their physical properties such as phase transition, ferroelectric/ ferro elastic behavior, phosphors, ionic conductivity. Oxide-ion conductors have many practical applications, such as oxygen sensors, membranes for separating oxygen and other gases, and solid electrolytes for solid oxide fuel cells [1].
Over the last ten years a new LAMOX family of oxide-ion conductors based on doped lanthanum molybdate $La_2Mo_2O_9$ with a high conductivity (0.06 S/cm at 800°C) has drawn the attention [2]. The compound exists at room temperature in the low-temperature monoclinic $\alpha$ phase, which passes to the cubic $\beta$ phase at 580°C; in this case oxide-ion conductivity increases by almost two orders of magnitude. To stabilize the cubic phase, which has higher conductivity than the low-temperature monoclinic phase, K+, Sr2+, Ba2+, Bi3+, V5+, S6+, Cr6+, W6+, and other ions can be used to suppress the $\alpha \leftrightarrow \beta$ phase transition. As a result, a phase transition from the low-temperature cubic $\beta$ phase with a statistical disorder of oxygen atoms to the high-temperature cubic $\beta$ phase with a dynamic disorder of oxygen atoms occurs around 450°C [3].
What is more, the mixed molybdates of lanthanides and lithium, $LiLnMo_2O_8$, can be used as laser waveguide materials. Their preparation by conventional solid state techniques is hindered by their complex composition and the existence of numerous thermodynamically stable lanthanide molybdate phases with close metal ratios [4], because of that there is a need to use 'soft' chemistry routes to create these compounds. The choice of synthesis technique usually depends on variety factors that can shorten, facilitates and reduce the preparation way. The use of solution chemistry, an aqueous sol-gel method in this case, can eliminate major problems, such as long diffusion paths, impurities, and agglomeration. Moreover, compared with other techniques, an aqueous sol-gel method has the advantages of a good control of the processing parameters. The use of sol-gel processing can eliminate major problems, mentioned above, which will result in products with improved homogeneity and the sintering temperature that usually strongly affects the properties of final compounds, which is crucial factor for the preparation of both nano-sized materials and thin films on different substrates [5]. From this point of view the most suitable technique to synthesize lithium lanthanum molybdate is an aqueous sol-gel synthesis method using tartaric acid as a precursor.
In this presentation, we report the synthesis of the Li-La-Mo-O tartrate gel precursor with the initial composition of the LiLaMo2O8 ceramic prepared by an aqueous sol-gel synthesis route using tartaric acid as a complexing agent. The thermal decomposition of Li-La-Mo-O was analyzed and investigated in detail. X-ray diffraction (XRD) and scanning electron microscopy (SEM) were used for the determination of crystal structure, surface morphology of the Li-La-Mo-O samples annealed at 350, 400, 450, 500, 600 °C temperatures, respectively.