A COMPARATIVE STUDY OF TRADE OFF FOR FET MATERIALS AND THEIR NANO-SCALE PERFORMANCE

M. H. Rubel1, Sabbir Ahmed Khan2, Shifur Rahman Shakil3, Sheikh Ziauddin Ahmed4

1 Department of Electrical and Computer Engineering, Boise State University, Boise, ID, USA

2 Department of Physics, Lund University, Sweden

3 BRACU Robotics, School of Engineering and Computer Science, BRAC University, Bangladesh

4 School of Engineering and Computer Science, BRAC University, Bangladesh

Over the years, researchers have been focused on FETs considering it as a promising device in the electronics industry as a result much concentration are given on to use different FETs material. Different dominant factors like reduced dimension, device density, switching speed and energy improvements are being considered while fabricating for nano electronic applications. To cope up with the revolution of electronic devices, microprocessor chips have become smaller day by day which suggests to place large numbers of transistor in single chip which results some problems including higher power consumption and heat dissipation. According to our study, we have presented a comparative analysis where we have explained the sequential comparison of using differ material as FETs in nano-electronic applications and their unique characteristics.

Carbon Nanotubes (CNT) are long, thin cylinders of carbon, which were first discovered in 1991 by S. Iijima. They may either consist of a single shell known as single wall nanotube (SWNT) or of several shells called multi wall nanotube (MWNT) [1]. Carbon Nanotube devices can operate in the ballistic regime due to the nanotube's one-dimensional structure, which greatly decreases the scattering probability [2]. But while solving the coupled Schrodinger-Poisson equations within the device cross sections and fully considering for quantum mechanical effects, an experiment was done for 65 to 45 nm technology nodes which showed an unexpected conclusion that for a predetermined threshold voltage, the gate-all-around CNTFET offers only a slightly better performance with respect to fully depleted cylindrical silicon nanowire FETs and four gate rectangular nanowire (4G RNW) FETs. As a consequences of research, Graphene was first explored by A. Geim, K. Novoselov and co-workers when they found the elusive free-standing graphene films [3]. Graphene can be used as superconducting FETs and transparent electrodes [4]. Despite having better mobility than typical silicon material and high –k, the performance of graphene devices can be limited by a critical issue which is poor contact resistance because currently the contact resistance values are in the order of kilo-ohms. Another problem of using graphene as an alternative material to silicon that has been explored is the absence of a bandgap between its conduction and valence band, literally which makes graphene based electronics to achieve low power dissipation in the OFF state [5]. At the end of 20th century, most of the efforts of nanowire devices have been focused on producing nanowire FETs. European research groups have made noteworthy contributions in the area including wrap gated Si [7] and InAs [6] nanowires and they attempted to engineer the bandgap of the channel of the device. It is a problem that the nanowire length and diameter need to be controlled within the much closed limits. When a material having a high dielectric constant serves as a gate dielectrode, nanowire surfaces should be properly passivated by either thermal oxidation or conformal atomic layer deposition [6]. Nowadays researchers have introduced two dimensional (2D) character of Molybdenum Disulfide (MoS2) like another grapheme material has attracted significant amount of attention due to its unique characteristics.

Acknowledgments: This work has been produced during my scholarship period at Lund University, thanks to Swedish Institute (SI.) scholarship.


[1] Franklin, N. R. et al., "Integration of suspended carbon nanotube arrays into electronic devices and electromechanical systems", Appl. Phys. Lett. 81, 913-915 (2002).

[2] Kong, J. et al., Quantum interference and ballistic transmission in nanotube electron wave-guides, Phys. Rev. Lett. 87, 106801 (2001)

[3] Britnel, L.et al, Field-Effect Tunneling Transistor Based on Vertical Graphene Heterostructures, Science 335, 947-950(2012)

[4] G. Fiori, G. Iannaccone "Code for the 3D Simulation of Nanoscale Semiconductor Devices, Including Drift-Diffusion and Ballistic Transport in 1D and 2D Subbands, and 3D Tunneling", Journal of Computational Electronics 4, 63-66 (2005).

[5] B. Obradovic, R. Kotlyar, F. Heinz, P. Matagne, T. Rakshit, M. D. Giles, M. A. Stettler, and D. E. Nikonov, "Analysis of graphene nanoribbons as a channel material for field-effect transistors," Applied Physics Letters 88, 142101.1-142101.3 (2006).

[6] Bryllert, T.,et al., Vertical High-Mobility Wrap-Gated. InAs Nanowire Transistor, IEEE Electron Device Lett. 27, 323(2006)

[7] Mårtensson, T.,et al., Epitaxial III-V nanowires on silicon, Nano Lett. 4 (2004)