SPATIALLY RESOLVED PHOTOLUMINESCENCE OF GaBiAs EPITAXIAL LAYERS AND GaBiAs/GaAs QUANTUM WELLS

Justinas Aleknavičius1, Darius Dobrovolskas1, Gintautas Tamulaitis1

1 Institute of Applied Research and Semiconductor Physics Department, Vilnius University, Saulėtekio Ave. 9-III, LT-10222 Vilnius, Lithuania

Recently, increasing interest has been addressed to dilute bismide semiconductor alloy GaBiAs. Introducing a small percentage of bismuth into gallium arsenide significantly reduces the band gap of the alloy. Moreover, the band gap of GaBiAs weakly depends on temperature. Charge carrier lifetimes in relaxed GaBiAs layers can be as low as 1 ps. These properties are beneficial for using GaBiAs in ultrafast infrared light emitters and detectors for optical fiber systems and terahertz applications [1]. However, growth of high quality GaBiAs is still a major challenge. GaBiAs epitaxial layers with relatively high Bi content (up to ~10%) but of rather poor crystalline quality can be grown at low temperatures (~240-380°C) [2]. Nevertheless, post-growth rapid thermal annealing (RTA) at high temperatures (~600-700°C) improves the crystalline structure of GaBiAs layers by creating bismuth-rich clusters, showing intense photoluminescence (PL) [3].

In this work, the PL properties of GaBiAs epitaxial layers and GaBiAs/GaAs quantum wells were investigated with spatial resolution. The GaBiAs structures used in this study were grown by molecular beam epitaxy (MBE) technique on GaAs substrates at the Center for Physical Sciences and Technology, Vilnius, Lithuania. Four low-temperature grown samples were investigated: three epilayers with different Bi content and a triple quantum well (QW) structure. The approximate percentage of Bi content in the samples was determined from the PL emission peak wavelength. The Bi molar fraction in the samples under study does not exceed 5%.

The samples were investigated using WITec Alpha 300S confocal microscope coupled to Andor spectrometer equipped with iDus InGaAs CCD detector array, capable of capturing spectra in near-infrared spectral region. The detector is thermoelectrically cooled down to -90°C. The spatial distributions of photoluminescence parameters were investigated by raster scanning randomly selected areas on the sample top surfaces with an objective of $60\times$ magnification (NA = 0.8). PL was excited using a continuous wave HeCd laser emitting at 442 nm. All the measurements were performed at room temperature.

The epitaxial layers exhibited PL bands peaked at 1060 nm, 1110 nm, and 1210 nm. These peak wavelengths correspond to Bi content of approximately 3%, 4% and 5%, respectively. The highest PL intensity was recorded in the sample with the lowest Bi content. The PL band experienced a red shift and a decrease in intensity as the Bi content in the alloy increased. Confocal PL imaging revealed that epilayers with Bi content of 3% and 5% have a striped pattern of PL intensity distribution, which is most probably related to different surface roughness in certain orientations. The epilayer with 4% Bi showed a spotted pattern of PL intensity distribution. The emission peak position varies from ~1110 nm in bright spots to ~1140 nm in background areas. Such distribution of the PL parameters is probably related to the inhomogeneity of Bi content in the sample.

The QW sample exhibits a single PL band peaked at 1050 nm. The PL intensity distribution in this sample is homogeneous except for dark spots or lines, which were shown to be associated with crystalline defects such as crystal lattice dislocations. A peculiar response to prolonged HeCd laser exposure was observed within this sample. The PL intensity in the spots or areas exposed to a highly focused laser beam for time periods up to 25 min increased by up to 35% (see Fig. 1). Moreover, the PL band undergoes a slight blue shift. Such laser annealing effect is associated with the diffusion of Bi ions to the GaAs capping layer due to excess thermal energy of the crystal lattice. In contrast to the results obtained in QW, the PL intensity of GaBiAs epitaxial layers diminished under laser exposure. The results show that the laser annealing can be used for optimizing the GaBiAs crystal quality.

Figure 1
Fig. 1. Spectrally integrated intensity mapping of the GaBiAs QW sample with laser annealed spots in the marked rectangular area induced by exposure varying from 10 s at the left to 45 min at the right of the mapping.

[1] K. Bertulis, A. Krotkus, G. Aleksejenko, V. Pačebutas, R. Adomavičius, G. Molis, S. Marcinkevičius, GaBiAs: A material for optoelectronic terahertz devices, Appl. Phys. Lett. 88, 201112 (2006).

[2] V. Pačebutas, K. Bertulis, G. Aleksejenko, R. Adomavičius, G. Molis, A. Krotkus, Growth and characterization of GaBiAs epilayers, Opt. Mater. 30 756–758 (2008).

[3] R. Butkutė, V. Pačebutas, B. Čechavičius, R. Adomavičius, A. Koroliov, A. Krotkus, Thermal annealing effect on the properties of GaBiAs, Phys. Status Solidi C 9, 1614–1616 (2012).