Carbon nanotubes (CNTs) are amongst the most promising nano-fillers due to their unique mechanical, thermal and electrical characteristics and have therefore been the subject of extensive research over the last few years by different methods. Issues such as the effect of CNTs volume fraction, degree of dispersion and filler/epoxy adhesion on the mechanical, thermomechanical of CNT-reinforced polymers have been addressed by a number of researchers. In view of the numerous factors that influence the microstructure of the CNT-filled polymer, reliable determination of its mechanical and thermal properties is really possible only through experiments.
Thus, the objective of the current work is to experimentally investigate the variation of the thermophysical and mechanical properties of a MWCNT/epoxy system with various loading content and to estimate correlation of the properties.
Dilatometric tests, thermal mechanical analysis (TMA), quasistatic tensile tests, hydrostatic weighting, and scanning electron microscopy (SEM) have been performed on the multiwalled carbon nanotube (MWCNT)/epoxy nanocomposite (NC) with different filler content (c = 0 -3.8% wt.) in order to determine the influence of MWCNT content on thermophysical and mechanical properties of the NC. The experimental results show similar and nonlinear behavior of the physical properties versus nanofiller content and the existence of the optimal MWCNT content (1% wt.) in epoxy resin that maximally improves the investigated properties of the NC in comparison with unfilled epoxy. The coefficient of thermal expansion is decreased by 68%, but glass transition temperature and the tensile strength is increased by 23 °C and 18%, respectively. Comparing the results it can be seen that after exceeding optimal filler content till 1.9% wt. the properties get worse, but after adding more MWCNTs (3.8% wt.) they again improve. The correlation between investigated mechanical and thermophysical properties is estimated and reported.
The main conclusion is that addition of more CNT into epoxy resin does not mean improvement of the NC properties, because due to high viscosity the dispersion of CNT is not uniform at higher loading systems. If optimal filler content is exceeded, the composite becomes defective and its properties get worse. It happens due to small nanoparticles agglomeration which results in a bad dispersion of nanofiller that generally means that NC has defects. Optimal percentage of filler is associated with sufficient quantity of nanofiller that can improve properties of NC and have good dispersion and high aspect ratio of particles in the material.