IN-SITU XAS MEASUREMENTS OF VANADATE-PHOSPHATE GLASSES

Krzysztof Gadomski1, Martyna Jankowska1, 2, Wojciech Tabiś3, Alexey Maximenko4, Sylwester Rzoska2, Tomasz K. Pietrzak1

1 Warsaw University of Technology, Faculty of Physics, Poland

2 Institute of High Pressure Physics, Polish Academy of Sciences, Poland

3 AGH University, Faculty of Physics and Applied Computer Science, Poland

4 SOLARIS National Synchrotron Radiation Centre, Jagiellonian University, Poland

The rapid growth of renewable energy production is an undeniable reality of the modern world. However, a major limitation of these energy sources is their strong dependence on weather conditions, which significantly reduces their reliability. This challenge necessitates the use of energy storage systems, such as batteries, to stabilise the power grid during unfavourable weather conditions or periods without sunlight.

Vanadate phosphates constitute a broad class of materials that are considered promising cathode candidates for lithium-ion batteries and have therefore been extensively investigated. Notable examples include crystalline VOPO\(_4\) [1] and Li\(_3\)V\(_2\)(PO\(_4\))\(_3\) [2]. Our group has also focused on glassy vanadate–phosphate systems, demonstrating that controlled thermal nanocrystallisation can substantially enhance their electronic conductivity. For example, V\(_2\)O\(_5\) P\(_2\)O\(_5\) glasses initially exhibit an electrical conductivity of approximately σ = 7 × 10\(^{-5}\) S/cm, which increases dramatically to σ = 7 × 10\(^{-2}\) S/cm at room temperature following nanocrystallisation [3]. Despite this significant improvement, the underlying mechanism responsible for the conductivity increase during crystallisation is not fully understood yet.

The aim of this study was to investigate the structural and electronic changes occurring in vanadate–phosphate glasses during heating from room temperature to temperatures well above the crystallisation point. For this purpose, in situ X-ray Absorption edge Spectroscopy (XAS) measurements were performed. This technique provides valuable insight into the evolution of both the local atomic and electronic structures during the crystallisation process. Results of this measurement as well as methodology will be presented.

Acknowledgments: M.J., K.G., and T.K.P. are grateful to the National Science Centre (NCN), Poland, for support in the framework of a grant OPUS-23 no. 2022/45/B/ST5/04005. We acknowledge the SOLARIS Centre for access to the beamline ASTRA where the measurements were performed, under the provision of the Polish Ministry of Science and Higher Education project "Support for research and development with the use of research infra-structure of the National Synchrotron Radiation Centre SOLARIS" under contract nr 1/SOL/2021/2.


[1] Z. Chen, Q. Chen, L. Chen, R. Zhang, H. Zhou, N. A. Chernova and M. S. Whittingham, "Electrochemical Behavior of Nanostructured e-VOPO4 over Two Redox Plateaus," Journal Electrochemical Society, vol 160, pp. A1777, 2013.

[2] H. Huang, S.C. Yin, T. Kerr, N. Taylor and L.F. Nazar, "Nanostructured Composites: A High Capacity, Fast Rate Li3V2(PO4)3/Carbon Cathode for Rechargeable Lithium Batteries," Advanced Materials, vol 14, no 21, pp. 1525-1528, 2002.

[3] T.K. Pietrzak, Ł. Pawliszak, P.P. Michalski, M. Wasiucionek and J.E. Garbarczyk, "Highly Conductive 90 V2O5 10 P2O5 Nanocrystalline Cathode Materials for Lithium-ion Batteries." Procedia Engineering vol 98, pp. 28-35, 2014