DYNAMIC NUMERICAL MODELLING OF TUMOR TISSUE ELECTROPORATION

Veronika Malyško-Ptašinskė1, Eivina Radzevičiūtė1, 2

1 Faculty of Electronics, Vilnius Gediminas Technical University, Vilnius, Lithuania

2 State Research Institute Centre for Innovative Medicine, Department of Immunology, Vilnius, Lithuania

Electroporation phenomenon nowadays is used in different spheres of application, covering cancer treatment. The method requires very precise designation of pulsing parameters and evaluation electric field distribution in tissue [1], where on of the most important parameters is tissue conductivity. From previous research it is known, that conductivity in tissue vary if electric field exceeds irreversible electroporation threshold [2]. Therefore, in this work conductivity dynamics were employed in numerical model. The results obtained from simulation creates a possibility of more accurate evaluation of electric field distribution and pre-treatment planning.

In this work the deep settled mice Lewis lung carcinoma (LLC1) three-dimensional tumor model was simulated in COMSOL Multiphysics (COMSOL, Stockholm, Sweden). Electric pulses were delivered through non-invasive plate electrodes placed with 3.8–4 mm distance between tumor tissue. In order to reduce inhomogeneity spaces between the electrodes and skin were partially covered with conductive gel [3] (conductivity of 1.1 S/m). Our purposed skin model involves an inhomogeneity of tissue structure considering skin multilayers such as stratum corneum with epidermis, dermis combination with fat, muscle and subcutaneous tumor, with corresponding parameters and thicknesses of mice skin layers [4] [5]. It has been already established that tissue conductivity is dependent on electric field strength, therefore, smoothed Heaviside function was employed in numerical modelling. In this function initial conductivity (0.003–0.5 S/m), reversible (150-400 V) and irreversible (800–1200 V) electroporation voltage values were defined for each layer [6][7][8]. The boundary conditions were characterized using Dirichlet's and Neumann boundary conditions, hence, two plate electrodes represent ground (0 V) and terminal (1,3 kV/cm amplitude value for μsPEF and 3,5 kV/cm – for nsPEF) with insulated outer boundaries. The results were obtained using stationary analysis.

It was observed that electric field strength in top and the bottom parts of the tumor was lowest, while the stratum corneum which was in contact with the electrodes received the highest dose of PEF and, therefore, increased possibility of skin ablation. It was observed that the amplitude of the pulsed electric field within the tumor can be increased more than 30%. Although, this may trigger even larger are of the tissue ablation. Volume fraction versus electric field shows that for micro second treatment whole tumor is affected by 1000 V/cm electric field strength, then the volume with higher value of electric field decreases. There are very little areas of tumor covered by electric field up to 1500 kV/cm. For nanosecond PEF 100% of tumor is covered by 1600 V/cm, then the curve decreases exponentially while reaches 3750 kV/cm. Moreover, the numerical modeling simulation results showed negligible deviation between computed and measured data.

It was shown that dynamic numerical modelling including the changes in conductivity while applying electric pulses can serve more precise spatial distribution of electric field in tumor tissue. However, our proposed model can be improved including the thermal calculations, which also have an effect on conductivity dynamics.

Acknowledgments: The research was funded by Research Council of Lithuania, Grant Nr. S-LL-21-4


[1] Pavselj, N. and Miklavcic, D., 2008. Numerical models of skin electropermeabilization taking into account conductivity changes and the presence of local transport regions. IEEE Trans Plasma Sci, 36(4), pp.1650-1658.

[2] Zhao, Y., Bhonsle, S., Dong, S., Lv, Y., Liu, H., Safaai-Jazi, A., Davalos, R.V. and Yao, C., 2017. Characterization of conductivity changes during high-frequency irreversible electroporation for treatment planning. IEEE Transactions on Biomedical Engineering, 65(8), pp.1810-1819.

[3] Ivorra, A., Al-Sakere, B., Rubinsky, B. and Mir, L.M., 2008. Use of conductive gels for electric field homogenization increases the antitumor efficacy of electroporation therapies. Physics in Medicine & Biology, 53(22), p.6605.

[4] Wei, J.C., Edwards, G.A., Martin, D.J., Huang, H., Crichton, M.L. and Kendall, M.A., 2017. Allometric scaling of skin thickness, elasticity, viscoelasticity to mass for micro-medical device translation: from mice, rats, rabbits, pigs to humans. Scientific reports, 7(1), pp.1-16.

[5] Hew, J., Solon-Biet, S.M., McMahon, A.C., Ruohonen, K., Raubenheimer, D., Ballard, J.W.O., Le Couteur, D.G., Nicholls, C., Li, Z., Maitz, P.K. and Wang, Y., 2016. The effects of dietary macronutrient balance on skin structure in aging male and female mice. PloS one, 11(11), p.e0166175.

[6] Forjanič, T., Markelc, B., Marčan, M., Bellard, E., Couillaud, F., Golzio, M. and Miklavčič, D., 2019. Electroporation-induced stress response and its effect on gene electrotransfer efficacy: In vivo imaging and numerical modeling. IEEE Transactions on Biomedical Engineering, 66(9), pp.2671-2683.

[7] Pavselj, N. and Miklavcic, D., 2008. Numerical models of skin electropermeabilization taking into account conductivity changes and the presence of local transport regions. IEEE Trans Plasma Sci, 36(4), pp.1650-1658.

[8] Corovic, S., Lackovic, I., Sustaric, P., Sustar, T., Rodic, T. and Miklavcic, D., 2013. Modeling of electric field distribution in tissues during electroporation. Biomedical engineering online, 12(1), pp.1-27.