INFLUENCE OF SOLVENT POLARITY ON STOBER PARTICLES SIZE

Pavlo Sivolapov1, Oleksiy Myronyuk1, Denis Baklan1, Valentyn Svidersky1

1 Chemical Technology Faculty, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Ukraine.

One of the current promising surface texture forming materials is nanosized silicon dioxide. An important requirement for the synthesis of SiO2 particles lays in ensuring uniformity of their sizes [1]. Among the known methods for regulating the size of silica nanoparticles (varying of reagent concentrations or temperature during synthesis), the effect of solvent polarity has been insufficiently studied [2].

The aim of this work is to describe the dependence of the effect of solvent polarity on particle sizes obtained during Stober synthesis.

SiO2 particles were obtained by Stober synthesis in this research. 1.5 ml of TEOS, 1.7 ml of NH3, 1 ml of deionized water and 50 ml of solvent pair were used for this purpose. After reaction mixture had been held on a magnetic stirrer at 40 °C 1 ml of TEOS was added and the reaction was proceeded for 2 hours. After washing, the resulting system was dried.

The polarity of the solvent was varied by adding miscible liquids with various HSP parameters to the main solvent (isobutanol). The effect of 3 additional solvents was studied: THF (polar), ethyl acetate (polar) and xylene (non-polar). Content of these liquids was 25, 33, 66, 75, 100 wt.% in relation to the amount of alcohol.

It was found, that increase of the co-solvent content led to size growth of nanosilica particles obtained in it (Table 1). Compositions with tetrahydrofuran shows the largest particles of silica (from 470 to 1455 nm) were formed in its presence, regardless of its content. Presence of ethyl acetate provides a similar case, but the particles formed in this system (from 536 to 1413 nm) are slightly inferior in comparison to obtained in THF ones. Adding of 33 wt. % of non-polar xylene to alcohol led to formation of the smallest particles with an average size of 226 nm. At the same time in the presence of 66 wt.% xylene were obtained particles with an average size of 1083 nm, which is the highest value for all studied systems with this content of co-solvent.

Table 1. minimum, average (mid) and maximum particle sizes of SiO2
Solvent content, wt. %Isobutanol – THFIsobutanol – Ethyl AcetateIsobutanol - Xylene
minmidmaxminmidmaxminmidmax
2545169712313686501355107271426
33323470699354629117838226494
66545887130631154775848510831658
753677361259339536695---
1009651455189858314132108---

Thus, the use of a polar solvent makes it possible to obtain larger particles with a uniform distribution, in contrast to the non-polar one.


[1] P. G. Pramila, M. Jaroniec, Renaissance of Stöber method for synthesis of colloidal particles: New developments and opportunities, Journal of Colloid and Interface Science, 584, 838-865 (2021).

[2] A. Kharchenko, O. Myronyuk, L. Melnyk, P. Sivolapov, Analysis of methods of regulation of silicon dioxide particles size obtained by the Stober method, Technology Audit and Production Reserves, 2(3(40)), 9–16 (2017).