Thermal reduction of graphene oxide (GO) is considered as a prospective technique for the simple, rapid, low-cost, and high yield preparation of graphene-based materials. However, this synthesis method has certain limitations, such as a high release of energy and the formation of structural disorders occurring during the reduction process [1]. Therefore, the thermal decomposition could be more precisely controlled and π-conjugated aromatic system may be effectively repaired by using additives. The reaction between malonic acid and phosphorus pentoxide at 150 °C temperature gives unstable carbon suboxide (C3O2) that decomposes into elemental carbon and carbon monoxide [2,3]. Thermal reduction of GO in the presence of C3O2 additive could be an effective method to tailor electronic properties, manipulate surface chemistry, and produce local changes to the elemental composition of the reduced GO (rGO) final material. The improved physicochemical characteristics could also positively influence the electrochemical performance of rGO in the detection of biomolecules. The sensitive and precise determination is extremely essential to detect low concentrations of dopamine (DA) in the human body since its abnormal levels can potentially lead to neurodegenerative disorders such as senile dementia, depression, Parkinson's and Alzheimer's diseases [4].
This study proposes the novel synthesis, characterisation and successful application of rGO as an electrochemical sensor for effective DA detection. Two GO samples have been prepared using modified Hummer's methods, including the pre-oxidation of natural graphite powder by mixtures of K2S2O8/P2O5/H2SO4 and H2SO4/H3BO3/CrO3 [5, 6]. Thermal reduction of GO samples has been carried out in the presence of malonic acid and phosphorus pentoxide additives under Ar gas atmosphere for 1 h at 800 °C temperature. Structural changes of rGO products obtained have been characterised by XRD, FTIR, XPS, and Raman spectroscopy techniques. The surface morphology of graphene-based samples has been studied using scanning electron and transmission electron microscopies. Electrical behaviour has also been determined by measuring the dependence between electrical conductivity and bulk density. The electrochemical measurements, including cyclic voltammetry (CV) and differential pulse voltammetry (DPV), have been performed to evaluate the sensitivity of rGO products (rGO1_10 and rGO2_10) towards DA detection.
The results obtained have shown that the thermal GO treatment using malonic acid and phosphorus pentoxide results in an efficient restoration of the π-conjugated system of graphene layers and an effect of P-doping. It indicates that the additive used in the thermal GO reduction plays a significant role in healing structural defects and increasing electrical conductivity in the rGO products. The CV studies have revealed that rGO1_10 and rGO2_10 samples exhibit prospective electrocatalytic activity towards the DA redox peak. The DPV studies have determined that the proposed sensor based on rGO2_10 demonstrate relatively high sensitivity (28.64 μA μM-1 cm-2) and low limit of detection (105 nM), showing that it is a promising electrode material for the sensitive DA detection.