HOT STAMPING AND VIBRATION BASED INNOVATIVE MICROSTRUCTURE FORMATION TECHNOLOGY

Justas Ciganas1, Giedrius Janušas1

1 Department of Mechanical Engineering, Kaunas University of Technology, Lithuania

Traditionally, the formation of microstructures is divided into stamping, photolithography, material removal, and deposition [1]. Combining different technologies can create an innovative and better-performing production method. The aim of this work is to improve hot stamping technology by using vibration. Vibration should improve hot stamping shape reproduction and high geometry filling at lower loads and temperatures [2].

Magnetostrictor actuator is the main device used in this application. Vibrations are generated by using the variable magnetic field and the magnetostrictive material [3]. The forming tool is heated by a ferromagnetic shunt and Eddy current. Vibration and heating can be controlled by three main parameters: frequency, voltage and current. In addition, the intensity of the deformations will be adjustable with an additional magnetization coil. Due to localized heating, it was decided to use a coolant to protect the magnetic coils. The results obtained from the simulations can be seen in Figure 1.

Figure 1
Fig. 1. Magnetostrictive deformations of the drive, the intensity of the magnetic field and the temperature curve.

Simulations show that at 1 tesla magnetic intensity, we can expect a temperature of about 200°C and a deformation of 4.5 μm. In Figure 1, it can be seen that the magnetostrictive material heats up even more, but due to intensive cooling its temperature does not rise above 320°C. The obtained results will be useful for further development of the technology and will be compared with experimental results.

Acknowledgments: This research was funded by a grant No. 0.1.2.2-CPVA-K-703-03-0015 “Development of new technology for the formation of microstructures in functional materials" from the European Regional Development Fund.


[1] Yu ChangKimab and Joo H.Kanga, Microfluidic biomechanical device for compressive cell stimulation and lysis, Sensors and Actuators B: Chemical 128, 108-116, (2007)

[2] Gracious Ngaile and Cristina Bunget, Influence of ultrasonic vibration on microforming,, Materials Science, (2008)

[3] Zhihua Wang and odher, Dynamics Compensation and Rapid Resonance Identification in Ultrasonic-Vibration-Assisted Microforming Syste Using Magnetostrictive Actuator, IEEE/ASME Transactions on Mechatronics, 16, 489-497, (2011)