STRONTIUM SUBSTITUTION EFFECT ON THE STRUCTURE, SURFACE MORPHOLOGY AND THERMOANALYTICAL PROPERTIES OF La2Mo2O9 SYSTEM

Giedrė Gaidamavičienė1, Artūras Žalga1

1 Faculty of Chemistry and Geosciences, Institute of Chemistry, Vilnius University, Naugarduko str. 24, LT-03225 Vilnius, Lithuania

Due to the increasing ecological requirements for power sources, oxide-ion conductors have garnered various researchers' attention due to their potential applications in solid oxide fuel cells (SOFCs) as a next generation of the green energy system. One of the most widely used and investigated electrolytes is yttria-stabilized zirconia (YSC) which has excellent ionic conductivity at high temperatures (1000 °C). However, high working temperature results in electrolyte performance degradation and shortens the lifetime of SOFCs systems. Therefore, low-temperature alternative electrolytes with enhanced ionic conductivities are being investigated [1].

Since the first report by Lacorre et al. [2] that the LAMOX family of oxides based on La2Mo2O9 can be a potential candidate for oxide-ion conduction a new window of materials in the field of oxide-ion conductors has been opened up [3]. This compound crystallizes into two different crystallographic modifications: low-temperature monoclinic α-phase and high-temperature cubic β-phase. It was found that the ionic conductivity of this material is strongly associated with the phase transition from monoclinic α-phase to cubic β-phase which occurs at 580 °C temperature. The main reason for the much higher ionic conductivity in the β-La2Mo2O9 crystal phase is related to the higher oxygen vacancies concentration in its structure, which creates additional paths for oxygen ions diffusion. Thus, the increase in the conductivity of oxygen ions has a close connection with the enhanced concentration of vacancies in the electrolyte structure.

The stabilization of high-temperature cubic phase by substituting of La sites with alkaline earth (Ca, Sr, Ba) metals remains a great challenge because of the enhanced suppression of β-phase, however, the introduction of extra oxygen vacancies leads to higher anionic conductivity of corresponding ceramic mixture [4, 5]. Gao clearly showed that a suitable amount of Sr doping in La2Mo2O9 not only can completely suppress the structural phase transition, resulting in high-temperature phase stabilization at room temperature but also can effectively increase oxide-ion conductivity of samples at higher temperatures [6].

The use of a conventional solid-state reaction method for the synthesis of La2Mo2O9 ceramic is most common because of the simplicity and high availability of this technique. Despite these advantages, the control of the mixing stage of starting materials remains the main drawback for solid-state synthesis which usually leads to impurities, higher porosity, and lower connectivity between grains in final ceramic. This side effect could be successfully eliminated by using so-called wet chemical techniques, which enable the enhancement of the mixing stage at the molecular level and improve the properties of final ceramics. Moreover, it is possible to control final ceramic molar composition, particle size, morphology, purity, homogeneity, and other properties by changing synthesis parameters like temperature, nature of the starting materials and complexing agent, concentration, pH, solvent, reaction time, etc.

In this study, the homogenous oxide-system for $La_{2-x}Sr_{x}Mo_{2}O_{9-\delta}$ (x=0.01-0.2) was prepared using an aqueous sol-gel synthesis method. This method is mainly based on the use of tartaric acid as a complexing agent that reduces interactions between the individual components avoiding the formation of precipitates during the evaporation stage from the reaction mixture. The thermal decomposition of La–Sr–Mo–O tartrate gel precursor and phase transition of $La_{2-x}Sr_{x}Mo_{2}O_{9-\delta}$ crystalline system was investigated by thermogravimetric analysis and differential scanning calorimetry (TGA-DSC). The obtained results clearly showed that the substitution effect stabilizes cubic β-phase for La2Mo2O9 at room temperature. Besides, no phase transition for the $La_{2-x}Sr_{x}Mo_{2}O_{9-\delta}$ samples from meta-stable cubic to monoclinic phase was observed. X-ray diffraction (XRD) analysis was performed in order to determine the crystal structure of the heat-treated ceramic materials. The microstructure and surface morphology of the ceramics heat-treated at 1200 °C of temperature were analyzed by scanning electron microscopy (SEM).


[1] C. Tian, L. Shao, et al., Synthesis and characterization of tungsten and barium co-doped La2Mo2O9 by sol-gel process for solid oxide fuel cells, Journal of Rare Earths, 37, 984-988 (2019).

[2] P. Lacorre, F. Goutenoire, et al., Designing fast oxide-ion conductors based on La2Mo2O9, Nature, 404, 856-858 (2000).

[3] S. Basu, P. Sujatha Devi, et al., Synthesis, thermal and electrical analysis of alkaline earth doped lanthanum molybdate, Solid State Ionics, 231, 87-93 (2013).

[4] C. Tealdi, G. Chiodelli, et al., Effect of alkaline-doping on the properties of La2Mo2O9 fast oxygen ion conductor, Journal of Materials Chemistry, 14, 3553-3557 (2004).

[5] D. Zhang, Z. Zhuang, et al., Electrical properties and microstructure of nanocrystalline $La_{2-x}A_{x}Mo_{2}O_{9-\delta}$ (A = Ca, Sr, Ba, K) films, 181, 1510-1515 (2010).

[6] X. Gao, T. He, et al., Structures, electrical and thermal expansion properties of Sr-doped La2Mo2O9 oxide-ion conductors, Journal of Alloys and Compounds, 464, 461-466 (2008).