THE DETECTION OF ANTIBODIES AGAINST SARS-COV-2 BY ELECTROCHEMICAL METHODS

Maryia Drobysh1, Viktorija Liustrovaite2, Alma Rucinskiene3, Ausra Baradoke1, Almira Ramanaviciene2, Ieva Plikusiene1, 2, Urte Samukaite-Bubniene1, 2, Roman Viter4, Chien-Fu Chen5, Arunas Ramanavicius1, 2

1 Department of Functional Materials and Electronics, State Research Institute Center for Physical Sciences and Technology, Lithuania

2 Department of Physical Chemistry, Faculty of Chemistry and Geosciences, Vilnius University, Lithuania

3 Department of Electrochemical Materials Science, State Research Institute Center for Physical Sciences and Technology, Lithuania

4 Institute of Atomic Physics and Spectroscopy, University of Latvia, Latvia

5 Institute of Applied Mechanics, National Taiwan University, Taiwan

The entry of the severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) into an organism is accompanied by a humoral immune response, namely, the expression of antigen-specific antibodies. The SARS-CoV-2 genome encodes four structural proteins, one of which, the spike protein, is commonly used as an antigen for specific antibody binding. Biosensors for detecting antigen-antibody interactions are widely used to diagnose coronavirus disease 2019 (COVID-19). Because of their low cost and simplicity without losing sensitivity and accuracy, electrochemical biosensors are one of the leading types of biosensors [1].

Our research aimed to model an electrochemical-based biosensor for the detection of antibodies against SARS-CoV-2 (anti-rS). In the biosensor, the recombinant SARS-CoV-2 spike protein (rS) was employed as a sensitive element. Electrochemical impedance spectroscopy (EIS) was chosen as the initial electrochemical approach since it is a non-destructive method for studying the phenomena occurring on modified working surfaces [2,3]. The next step was to adapt and apply the approach for other electrochemical methods, namely, cyclic voltammetry (CV). CV is used to obtain data on the redox potential and other electrochemical characteristics of analyte solutions, as well as to monitor the processes occurring on the working surface [4].

For EIS based experiments anti-rS were detected by the gold electrode modified with a self-assembled monolayer (SAM), namely, 11-mercaptoundecanoic acid (11-MUA), followed by the covalent immobilisation of rS [5]. Following each stage, EIS measurements indicated correlations between impedimetric signals and working surface modification. On the crucial step of the anti-rS coupling, we observed a considerable increase in electron-transfer resistance. Nevertheless, when it came to CV, this immobilisation approach has been proved to be ineffective. CV showed that the SAM was densely packed and blocked the gold surface, which significantly hindered the transfer of electrons and, therefore, made it practically impossible to detect the signal at the subsequent stages of rS immobilisation and anti-rS coupling. We adjusted the immobilisation method by lowering SAM density through the use of mixed 11-MUA and 6-mercapto-1-hexanol as a spacer (SAMmix) [6]. The improved immobilisation technique allowed performing CV based experiments and the resulting cyclic voltammograms revealed the decrease of current density after the electrode modification with SAMmix and continuing sequential working surface insulation after rS immobilisation and anti-rS coupling.

Thus, it can be concluded that the modified technique makes it possible to adapt the experiment for other electrochemical methods, such as differential pulse voltammetry, chrono pulse amperometry, etc.

Acknowledgments: This research was conducted under Lithuanian-Latvian-Taiwan project and it has received funding according to agreement No S-LLT-21-3 with Research Council of Lithuania (LMTLT).


[1] M. Drobysh, A. Ramanaviciene, R. Viter et al., Biosensors for the Determination of SARS-CoV-2 Virus and Diagnosis of COVID-19 Infection, International Journal of Molecular Sciences 23(2), 666 (2022).

[2] A. Ramanavicius, A. Finkelsteinas, H. Cesiulis et al., Electrochemical impedance spectroscopy of polypyrrole based electrochemical immunosensor, Bioelectrochemistry 79(1), 11-16 (2010).

[3] V Liustrovaite, A. Valiuniene, G. Valincius et al., Electrochemical Impedance Spectroscopy Based Evaluation of Chlorophyll a Reconstitution within Tethered Bilayer Lipid Membrane, Journal of The Electrochemical Society 168(6), 066506 (2021).

[4] V. Ganesh, S.K. Pal, S. Kumar et al., Self-assembled monolayers (SAMs) of alkoxycyanobiphenyl thiols on gold - A study of electron transfer reaction using cyclic voltammetry and electrochemical impedance spectroscopy, Journal of Colloid and Interface Science 296, 195–203 (2006).

[5] A. Ramanaviciene, A. Kausaite-Minkstimiene, A. Ramanavicius et.al., Comparative study of random and oriented antibody immobilization techniques on the binding capacity of immunosensor, Analytical Chemistry 82(15), 6401-6408 (2010).

[6] V. Sharma, V.K. Tanwar, S. K. Mishra et al., Electrochemical impedance immunosensor for the detection of cardiac biomarker Myogobin (Mb) in aqueous solution, Thin Solid Films 519(3), 1167-1170 (2010).