SORPTION PERFOMANCES OF MgFe2O4 SPINEL TOWARDS Mn2+, Cu2+, Co2+, Ni2+ IONS

Marina Roshchina1, Andrei Ivanets2, Vladimir Prozorovich2, Elena Petrova1, Vladimir Pankov1

1 Department of Physical Chemistry, Belarusian State University, Belarus

2 Laboratory of adsorbents and adsorption processes, Institute of General and Inorganic Chemistry, National Academy of Sciences of Belarus

Due to industrialization the global production of products containing toxic metal ions has increased as well as amount of toxic metal-containing wastewater released by industries [1]. Removal of these metal ions from water has a high priority because even low concentration can cause severe damage to living organisms and the environment [2]. In recent years nanosized spinel ferrites (SFs) with a general formula MFe2O4 have been widely used as adsorbent due to their high surface area, simplicity of separation and superparamagnetic properties [3-4]. MFe2O4 nanoparticles have stronger magnetic features and higher chemical resistance to oxidation in comparison with iron oxide [5-7]. Also, SFs can be characterized by a high stability in acidic medium (pH 2.0-6.0) which allows to use it within a wide pH range. In addition, SFs are used as heterogeneous Fenton-like catalyst for oxidation destruction of organic materials in the presence of H2O2, O3 and other OH precursors [8]. For all these reasons, SFs are attractive materials for the development of effective adsorbents and Fenton-like catalysts.

In this work MgFe2O4 was used as a non-toxic sorbent of heavy metal ions. Magnetic particles of MgFe2O4 were prepared by different methods: spray pyrolysis, glycine-nitrate combustion synthesis, co-precipitation, spray-drying synthesis. The phase composition and morphology of the powdered samples were investigated with X-ray diffraction (XRD), scanning (SEM) and transmission electron microscopy (TEM). Analysis of residual concentration of ions in aliquot was carried out using atomic absorption spectrometry (AAS). Percentage removal of metal ions and amount of metal ions adsorbed onto MgFe2O4 nanoparticles were calculated by the following equations:

$$ \text{Removal ions (%)} = \frac{(C_i - C_e)}{W} \cdot 100 \tag{1} $$ $$ q_e = \frac{(C_i - C_e)}{W} \cdot V \tag{2} $$

Where qe is the adsorption capacity (mg/g), W is the mass of adsorbent (g), V the volume of the solution (L), Ci and Ce are the initial and the equilibrium concentrations of metal ion (mg/L).

According data of adsorption different metal ions (Mn2+, Cu2+, Co2+, Ni2+) onto SFs, the method of SFs synthesis does not significant effect on the capacity of obtained magnetic adsorbents. It was determined that the highest adsorption affinity SFs demonstrate towards Mn2+ (101,8 mg/g) and Cu2+ (85,0 mg/g) ions. However, adsorption capacity slowly decreases with increasing of their crystallinity structure and magnetic properties. Therefore, it is necessary to determine the optimal conditions to preserve high sorption and magnetic properties of SFs.


[1] J.O. Nriagu, J.M. Pacyna, Quantitative assessment of worldwide contamination of air, water and soils by trace metals, Nature 333 134-139 (1988).

[2] S.L. Begg, B.A. Eijkelkamp, Z. Luo et al., Dysregulation of transition metal ion homeostasis is the molecular basis for cadmium toxicity in Streptococcus pneumoniae, Nat. Commun. 6 (2015).

[3] V. Srivastava, Y.C. Sharma, M. Sillanpää, Application of nano-magnesso ferrite (n-MgFe2O4) for the removal of Co2+ ions from synthetic wastewater: Kinetic, equilibrium and thermodynamic studies, Applied Surface Science 338 42-54 (2015).

[4] V. Srivastava, T. Kohout, M. Sillanpää, Potential of cobalt ferrite nanoparticles (CoFe2O4) for remediation of hexavalent chromium from synthetic and printing press wastewater, Environmental Chemical Engineering Vol 4 Iss 3 2213-3437 (2016).

[5] J. Liu, Y. Bin, M. Matsuo, Magnetic Behavior of Zn-Doped Fe3O4 Nanoparticles Estimated in Terms of Crystal Domain Size, J. Phys. Chem. C 116 134-143 (2012).

[6] Q. Song, Z.J. Zhang, Correlation between Spin-Orbital Coupling and the Superparamagnetic Properties in Magnetite and Cobalt Ferrite Spinel Nanocrystals, J. Phys. Chem. B 110 11205-11209 (2006).

[7] N.M. Jacob, P. Kuruva, G. Madras, T. Thomas, Purifying Water Containing Both Anionic and Cationic Species Using a (Zn, Cu)O, ZnO, and Cobalt Ferrite Based Multiphase Adsorbent System, Ind. Eng. Chem. Res. 52 16384-16395 (2013).

[8] Y. Wang, H. Zhao, M. Li, J. Fan, G. Zhao, Magnetic ordered mesoporous copper ferrite as a heterogeneous Fenton catalyst for the degradation of imidacloprid, Applied Catalysis B: Environmental 147 534-545 (2014).