SPONTANEOUS EMISSION FACTOR INFLUENCE ON OUTPUT PARAMETERS OF THE VERTICAL-CAVITY SURFACE-EMITTING LASERS

Labatsevich Pavel1

1 Department of Physics, Belarusian State University, Belarus

The magnitude of spontaneous emission factor contribution into the lasing mode (parameter β) is very important characteristic, that determines energetic and dynamic characteristics of semiconductor lasers. For vertical-cavity surface-emitting semiconductor lasers (VCSEL) the experimental values and theoretical estimates give a very wide variation in the range from 10-2 to 10-6, and there are no criteria that would significantly clarify the range of the parameter β determination nowadays. This work presents the results of numerical simulation of the intensity and the degree of polarization of the output radiation, in which the β acts as a fitting parameter. The initial model was analyzed on the base of the polarization components method [1,2]. Previously, this method has shown high efficiency for the description the polarized light formation in VCSEL polarization instability area.

It has been shown that increase of the parameter β results in effective reduction of the induced anisotropy that leads to a significant reduction in the degree of the output radiation polarization. As a result, the latter does not reach the limiting values even far from the point of polarization switching, which corresponds to a significant expansion of the polarization switching area, even in the case of stationary excitation, that has not been experimentally observed. This effect may occur already at β values greater or equal to 10-4.

Since β is usually determined as a particular value at the lasing threshold, the possible dependence of β on the injection current density has been investigated. Calculation results have shown that the dependence of the polarization degree on the injection current is weak even for a significant change of β.

Thus, the numerical simulation results showed that the optimal β values belong to the range 10-5 -10-6, in which the calculated dependences match well with the experimental data.

According to the classical theory of semiconductor lasers, the spontaneous emission intensity fluctuations determine the statistical characteristics of the output radiation. The analysis of the statistical modeling results for the VCSELs in polarization instability area has shown that the numerical value of the distribution function dispersion is substantially lower than experimentally observed, especially for the intensity providing the distribution function for the intensity and degree of polarization are qualitatively similar to those observed experimental data. Thus, we can assume that the spontaneous emission is an important, but not dominated factor. However, there are other factors (for example, fluctuations in the concentration of nonequilibrium carriers and injection current), which may be more significant in terms of the statistical parameters formation of the output radiation, at least for the VCSEL in polarization instability area. Probably this overestimation of the spontaneous radiation is reflected to the fact that experimentally observed values of β are two or three orders of magnitude higher than the values used in the theoretical calculations.


[1] [1] M. Jadan, L.I.Burov, A.S.Gorbatsevich, E.S.Sokolov, Polarization switching in single-mode injection semiconductor laser, Journal of Applied Spectroscopy 76, 717-724 (2009).

[2] [2] M. Jadan, L.I.Burov, A.S.Gorbatsevich, E.S.Sokolov, Dynamics of polarization switching in single-mode injection semiconductor lasers, Journal of Applied Spectroscopy 77, 65-72 (2010).