DRAG FORCE AND QUARTZ RESONATOR ADMITTANCE STUDY OF AQUEOUS SOLUTION LAYER PROPERTIES AT POLYMER COATED ELECTRODE SURFACE

Arūnas Pulmanas1, Filipas Ambrulevičius1

1 Department of Applied Chemistry, Vilnius University, LT-01513 Vilnius, Lithuania

Reduction of water flow friction by applying electric potential to the pipe wall [1] can contribute to the ability to actively manipulate a wall-bounded liquid flow field to effect a desired change. This effect has been tested in two Norwegian hydroelectric power stations [2]. However, the mechanism of this effect is not entirely clear, but it is hypothesized that this phenomenon is related to structural changes of water due to electric field in a double layer region. Piezoelectric resonator measurements show that there is a minimum of interfacial viscosity of aqueous solutions (approximately 1% of the bulk viscosity) at the potential of zero charge of gold electrode [3], [5]. Drag force measurements confirm interfacial viscosity dependence on the potential obtained from piezoelectric resonator measurements but the minimum is lower (approximately 5% of the bulk viscosity) [5].

Computer controlled fluid circulation system for measuring the drag force of the body, whose electrode potential can be controlled independently, was built. By using this technique the potential dependence of the drag force on a polymer (PV butyral) coated sphere was measured in a stream of 0.1 M sodium fluoride (99%, Roth) solution prepared in distilled water. Then the drag coefficients were calculated for the sphere via Eq. (1) and corrected for the wall effect [4].

$$C_D = 8F_D / (\pi \rho v^2 d^2)\tag{1}$$

The LOESS (local smoothing technique with tri-cube weighting and polynomial regression, (sampling proportion and polynomial degree equal to 0.3 and 1, respectively) procedure was used to smooth the drag force data as a function of the potential. Viscosity values were calculated from drag force values by using empirical relationship, which for the Reynolds number range from 1.5×103 to 1.2×104 are [4]

$$\lg C_{\mathbf{D}} = 2.4751 + 2.5558w - 0.9295w^2 + 0.1049w^3 \text{ (} w = \lg \text{Re}_{\mathbf{d}}\text{)}\tag{2}$$

Quartz resonator admittance is $$\tilde{Y} = G + jB$$, where $G$ is conductance and $B$ is sucseptance. In present work for the non-damped resonator (resonator in contact with air) or for the fixed electrode potential, when resonator is in contact with solution, frequency spectra of admittance magnitude $Y = \sqrt{G^2 + B^2}$ and phase angle $\phi = \arctan B/G$ were measured and recalculated into $G$ and $B$ frequency spectra. From these spectra, a set of elements of the electrical equivalent of quartz resonator (Butterworth-Van-Dyke equivalent circuit) was calculated. Then, the obtained sets of circuit element values were used to calculate the changes of electrode mass and liquid properties (viscosity and density product).

In present work, it was observed that change of interfacial viscosity with potential correlates with the dependence of interfacial viscosity and density product on the potential, which was obtained by using quartz sensor. It should be noted and emphasized that the character of interfacial viscosity change with potential of polyvinyl butyral coated electrode is the same as in case of electrode with clean metallic surface.

The results obtained demonstrate that polymer coated surfaces can be used instead of metallic surfaces. That increases the technological potentiality of the effect observed because the disadvantage of metallic surface is their corrosion when they are positively polarized.

The results obtained increase the ability to actively manipulate a wall-bounded liquid flow field to effect a desired change what is of great technological importance: lower wall viscosity ($$\delta \eta / \delta x > 0$$) will cause the curvature of the velocity profile at the wall to become more negative what increases the lower critical Reynolds number and reduces amplification rates of unstable waves and, hence, increases the flow stability and its resistance to boundary-layer separation.


[1] M. Waskaas, US Patent No US 6,334,957 (2002).

[2] M. Waskaas , V. Daujotis , K. E. Wolden , R. Raudonis , D. Plausinaitis, Russ. J. Electrochem. 44, 609 (2008).

[3] V. Daujotis, D. Plausinaitis, M. Waskaas, R. Raudonis, 9th Spring Meeting of the ISE, May 8 to 11, 2011, Turku, Finland.

[4] R. Clift, J.R. Grace, M. E. Weber, Bubles, drops and particles, Academic Press, New York, 1978.

[5] D. Plausinaitis, F. Ambrulevicius, V. Daujotis, Int. J. Electrochem. Sci. 10, 7251 – 7260 (2015).