Laser diodes (LD) based lightning is becoming more promising as a future high power lightning technology. It is already used in automotive headlamps at BMW and Audi and it also has other applications such as white fiber light [1]. LDs exhibit greater output power at higher efficiency since they do not suffer efficiency droop which limits the brightness of light emitting diodes (LEDs). Although this brightness limit is not crucial for general lightning, higher light intensity per area is needed in some specific applications as mini projectors, car headlamps and narrow beam outdoor torches which require quasi-point source of light. For this case it is of interest to improve LDs based lightning technologies. As for LEDs, one of the ways to obtain white light is to use a blue LD and an inorganic phosphor which converts part of blue light to yellow. Even though the process of photoluminescence (PL) remains the same under the excitation of both LED and LD, the power density of LD is much higher. This causes the heating of a converter due to Stokes shift when energy is released as heat and therefore thermal phosphorescence quenching is induced. It results in a reduced output power and a shift of colour coordinates of phosphor conversion LD. For this reason it is important for a phosphor to have as good thermal conductivity as possible to avoid catastrophic rise of temperature.
YAG:Ce3+ phosphor is one of the most commonly used phosphors for lightning [2]. It has excellent mechanical and chemical properties. Broad emission spectrum that peaks at 550 nm together with a blue LD light create white light and therefore this phosphor is widely used in lightning industry. For the above mentioned reasons ceramics and powder YAG:Ce3+ phosphors were chosen to be investigated and compared under the LD.
In this work, photoluminescence decay time of powder and ceramics YAG:Ce3+ phosphors at different temperatures was estimated using the frequency-domain technique. This method is based on phase shift of the sinusoidal PL signal relative to that of the photoexcitation signal. As an excitation source Osram LD (450 nm, 1.6 W) was used. It was modulated by driving high-frequency (0.1 – 50 MHz) current. For calibration purposes ceramics and powder YAG:Ce3+ phosphors were embedded in cryostat and their PL decay times dependency on temperature were measured using low power LD light. Later phosphors were withdrawn from controlled temperature environment, and the PL decay time was measured as a function of excitation power. Temperature of YAG:Ce3+ nanoparticles in powder and ceramics phosphors were determined on the basis of calibration measurement described above.
During the investigation the temperatures of powder and ceramics phosphors as functions of excitation power were compared. The results have shown that ceramics phosphors have better thermal conductivity and are more stable under high excitation power density.