SYNTHESIS OF LITHIUM-IRON SILICATE Li2FeSiO4 USING SOL-GEL METHOD

Maksymilian Odziemczyk1, Przemysław P. Michalski1, Jerzy E. Garbarczyk1

1 Faculty of Physics, Warsaw University of Technology, Koszykowa 75, 00-662, Warsaw, Poland

The purpose of this work is synthesis of cathode material for Li-ion batteries, Li2FeSiO4. This material offers a promising opportunity for batteries due to its high theoretical capacity of 331 mAh·g-1. Voltage of cell consisting Li2FeSiO4 as a cathode is expected to be as high as 4.0-4.8 V vs Li+/Li. Low cost and high abundance of substrates are also the advantages of this material. On the other hand, a disadvantage of Li2FeSiO4 is extremely low electronic conductivity of $6\cdot10^{-14}$ S\cdotcm-1 [1]. Such low value may worse its electrochemical properties. Sol-gel method enables to obtain a material of high porosity and so that the both ionic and electronic conductivity may be higher [2].

In our case, the source of silicon was TEOS ($SiC_8H_{20}O_4$). TEOS was dissolved in distilled water and ethanol solution. Water solutions of lithium and iron sources ($CH_3COOLi$ and $Fe(NO_3)_3\cdot 9H_2O$) were added dropwise. Final solution was mixed on magnetic stirrer and temperature was rised up to 80-90°C in order to evaporate the excess of water. The pH of solution was controled by adding 2M solution of ammonia. After gelation, the obtained gel was dryed in vacuum dryer.

Figure 1
Fig. 1. Possible crystal structures of Li2FeSiO4: a) monoclinic, b, c) orthorhombic. Pink and brown – LiO4 tetrahedra, blue colour – SiO4 tetrahedra, green colour – FeO4 tetrahedra [1].

In this poster, results of studies on pH influence on Li2FeSiO4 sol-gel synthesis process will be shown.


[1] J. Ni, Y. Jiang, X. Bi, et al., Lithium Iron Orthosilicate Cathode: Progress and Perspectives, ACS Energy Letters 2, 1771-1781 (2017).

[2] V. Etacheri, Sol-Gel Processed Cathode Materials for Lithium-Ion Batteries in Sol-Gel Materials for Energy, Environment and Electronic Applications (Springer, 2017).